Mega Dual Coil Cartomizers won't work.

[Zurina]

Well I ordered some Mega Dual Coil Cartomizers 5 mil from madvapes, but I can not get it to work on my Volcano Inferno. Was wondering, is there anything I can do or maybe it just won't work on it. I have heard so many great things about them. If anyone has any advice for me, I would appreciate it. Thank You.

 

[ShoeQueen]

Try taking a look at the bottom of the carto. Is the center post receded? You can use a tweezers to gently pull/work that center post up, so that it is flush or slightly higher than the outer rim. Not sure if this will help, but it's worth a shot.

 

[sierra22]

Had the same issue last night. The "skirt" of the cartomizer (the part that goes down past the connector on the cartomizer)that goes down where the o-ring on the inferno is, is too long, what I did is used the shorty 510-510 extension, works just fine. I also have an ego knock-off that has the threads, instead of the o-ring and it works without an adapter....its just an inferno thing. you can try to pry out the center pin a little bit to see if its enough to make contact, but it wast for me....the "skirt" didnt allow the cartomizer to screw all the way down.