TC with 0.3 SS coil

[Seth94]

Hi, need some advice on a problem i have. I have the following setup:
eleaf 100W TC
EC 0.3 ohm coil (eleaf)

I´m trying to use the coil is TC(SS-mode) but it keeps leaving it going into wattage mode.
I guess this might be beacause the dual coil is not supported? So then my question is, can i use a custom TCR value to use it? And what value would be suitable for this dual coil to get a correct temperature reading as well as a valid wattage output?

Grateful for all answers!

 

[edyle]

Maybe it's not actually a stainless steel coil.

 

[Seth94]

Maybe it's not actually a stainless steel coil.

Actually it seems to be kanthal wire, good point!
Would kanthal be possible to use with TC? And what TCR value would i use?

 

[edyle]

Actually it seems to be kanthal wire, good point!
Would kanthal be possible to use with TC? And what TCR value would i use?

It's not practical;
I think the tcr value would be around 20 (on the evic vtc mini)

But the ohm variations you get from other things going on (themal expansion causeing pressure variation on the centerpin contact, and variations in connectivity at the points where the coil legs contact the housing and pin) get to be significant.

 

[OhTheAgony]

Just get a proper coil that's meant to be used with TC instead, from what I gather it will save you a ton of frustration.

 

[Seth94]

What about the Aspire triton 316L? Also it should work with the ijust2 tank right?

 

[Imfallen_Angel]

hmm. Kanthal does not do TC, like, it's impossible... it's either NI200, TI, or SS for TC.

Just read up on how TC works if you need more info about TC.

how temperature control works vaping - Google Search