@homeuser6 sent me an RSST genny with a 2.08ohm kanthal coil, wrapped around 3mm Ekowool. He vapes on a mech so he asked me to measure that set of parameters. juice was about 85/15 VG/DW.
Note that this was a "modded" top cap and had four 1mm airholes. This made a huge difference as when I taped off 3 of the airholes the temperatures at every setting rose 50-100 degrees.
Even on a fresh battery (4.2v) this build looked good.
This is 3 5-sec puffs with a break in between followed by a couple of chain vapes
Probe inserted easily on this build:
And for the full stats (he said he never lets his bat drop below 3.6v):
ETA: DL hits were about 25% lower in temp, and quite tasty, I would rather enjoy that setup with a little higher nic.
©2017 Mike Petro. This is an open access article distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited.
Note that this was a "modded" top cap and had four 1mm airholes. This made a huge difference as when I taped off 3 of the airholes the temperatures at every setting rose 50-100 degrees.
Even on a fresh battery (4.2v) this build looked good.
This is 3 5-sec puffs with a break in between followed by a couple of chain vapes
Probe inserted easily on this build:
And for the full stats (he said he never lets his bat drop below 3.6v):
ETA: DL hits were about 25% lower in temp, and quite tasty, I would rather enjoy that setup with a little higher nic.
©2017 Mike Petro. This is an open access article distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited.