@Mordacai and @AngeNZ, Many thanks to you both for your input. Has given me plenty of avenues to explore, which is ideal considering the lack of choice in these parts.
Never considered Eleaf Pico as when I was looking before, it seemed to have a few quality problems, but at least it seems to be...
Have been out of the loop for a while as I have been quite content with my MVP4s and KF Lites, but the mods are now in need of replacing, and I am considering either the YiHi SX mini or the Jac Vapour SERIES -B DNA 75W which are available here. Fairly limited choice here after legislation came...
@Rcon many thanks for the advice. Yes the doggy certainly presents challenges for us TPs. I really didnt realise that my preference for a tight draw was so extreme. I always assumed that we were all looking for a cigarette type draw. Learned something anyway.
I recently thought I would graduate...
Having just received my first Doggies (SXK) I must be another tootle puffer who expected too much regarding airflow. I am having to close it down to an almost invisible "hole" to get anywhere near a cigarette type draw.
Quite disappointed really. Probably expecting too much after all the...
I can see that it may be possible to use the new top-fill tank with the 2k16 bases, but a) it does introduce a second thread to cause extra potential wear in the PC tank, and b) I can only see PC 2k18 tanks being available and not (so far) any acrylics.
I think they have also missed an...
To be honest, the only thing that I have not tried (because I didn't think of it, and being too focused on the actual build) is the make-up of the juice. I only vape home-made menthol at 65/35 pg/vg which I always thought was a fairly average mix for most builds. You have at least given me an...
Many thanks for the replies.
As explained, over the years I have tried just about all combinations of wicking and coils at any and all wattages/temps, coil sizes from 2.0mm to 3.0mm. The point about using the squarish cotton in a round coil is also something that I have tried to obviate, by...
Many thanks for the reply Ryedan.
I use 28g 316L and KGD cotton, and when I say I have tried packing the wick tight, I mean up to and past the point where the coil distorts and has to be restrained by my fingers, or dragged back into its position. This has been in desperation, but really knowing...
I have been vaping for 5 years, the last 4 of which has been with Kayfun Lites etc. With spare parts being a bit more difficult to source, I feel it is time to replace them with perhaps the Doggy which seems like it could be an equivalent vape to the Kayfuns. I have tried the Siren 2 which...
I have consigned them all to the "parts" box, as the 510 threading is so rough on these bases, it is chewing up my mod threads.
Many thanks for the links to the alternatives. I will replace them when I am financially able. Such a waste.
Thanks to all for your help.
Any help appreciated.
just received and built these:-
$11.21 Kayfun Bell Cap Kit w/ 510 Drip Tip (5-Pack) 5-pack - acrylic + stainless steel / ant logo at FastTech - Worldwide Free Shipping
$4.64 Replacement Base for Kayfun Lite Five Pawns - stainless steel at FastTech - Worldwide Free...
Been vaping for 4 years. Started on Kanthal and fairly recently graduated to 316L. Same thing with both. I NEVER burn out a coil in either material. They would last a year if I didnt get bored and just replaced them- because I think I should.
Usually, a dry burn and wash sees the coil almost as...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.