Goblin Mini 3 510 pin...shortened? Won't connect to mods, bith pins go up past the 510 threads

[Labubs]

I can fiddle and be delicate and get a connection, but both the 510s, Copper and SS have the same problem. I think the insulator is to blame perhaps. Anyone know where I can replacement S for both the above parts and/or just black bases? It's my favorite atty....

 

[DaveP]

The easy way out is a 510 heat sink that screws onto the atomizer and into the mod. Screws on input and output are adjustable for contact. If that atty is the only one you have problems with, just leave the adapter on it. I use one on my RX200S to keep the heat in the atty and out of the mod. The case was getting too hot for my taste.

510 heat sink | eBay

 

[Labubs]

Thank you, I had tried that. Just noticed the typos on my OP, did that on mobile.....but the problem is I believe the insulator , as both pins have the same problem. The actual pin that makes contact is allowed to go up past the outer screw part and make no connection, due to the juice flow design this will happen all the time. Hm, maybe I'll try insulators off retired attys, especially UD ones, there's bound to be one that fits and keeps that pin lower than the screw.