I've got a couple of the Janty "high brass" atomizers, and I notice different performance from them than I do the "low brass" atomizers I received from Widow's Beadwork.
The wicking bridge on the 'high brass' atomizers seems to be appreciably taller than on the 'low brass'. I've noticed the following:
Lower cartridge 'fill' level and easier flooding - I'm presuming this is due to the higher wicking bridge putting more pressure on the fiberfill inside the cart.
I've also noticed a short-circuit sort of 'pop' from the atomizers, as well - maybe due to the fibers hanging off the wicking bridge that aren't there on the 'low brass' one?
I do seem to get a little more consistent hit from the high brass atomizers, though....
Anyone else seeing any of these issues?
The wicking bridge on the 'high brass' atomizers seems to be appreciably taller than on the 'low brass'. I've noticed the following:
Lower cartridge 'fill' level and easier flooding - I'm presuming this is due to the higher wicking bridge putting more pressure on the fiberfill inside the cart.
I've also noticed a short-circuit sort of 'pop' from the atomizers, as well - maybe due to the fibers hanging off the wicking bridge that aren't there on the 'low brass' one?
I do seem to get a little more consistent hit from the high brass atomizers, though....
Anyone else seeing any of these issues?