I just bought a Kanger Evod VV eGo Battery - what coils should I use?

Discussion in 'New Members Forum' started by Leslie in Raleigh, Dec 13, 2013.

Thread Status:
Not open for further replies.
  1. Leslie in Raleigh

    Leslie in Raleigh Full Member

    I have the Kanger EVOD BCC, and thought that I would try a variable voltage also. The coils that apparently come standard with the BCC are 2.5ohms...some people here have suggested using a 1.8ohm coil for better throat hit...

    ...my question is: should I use the 2.5ohm coil on the VV battery?

    Sorry, but I'm new to this, and it is rather overwhelming...
     
  2. ncvapfan

    ncvapfan Senior Member ECF Veteran

    I prefer the 2.5 coils . Try 4-4.2 volts on your battery . The coils are pretty cheap you can always try a 1.8. That's the great thing about vv you can tweek it to your liking
     
  3. DavidOck

    DavidOck Vaping Master ECF Veteran

    Supporting member
    Right.. VV / VW is so you can adjust the vape to your tastes, regardless of the coil resistance. (Up to a point, of course. Too low is seen as a short, too high and you can't get enough power.)

    Anything in the 1.8 to 2.8 range should work fine with your setup. Start with the battery set low, and work up to taste.
     
  4. Topwater Elvis

    Topwater Elvis Ultra Member ECF Veteran

    The whole point to using a VV / VW power device is to be able to adjust the power up /down to find your sweet spot using a variety of resistance delivery devices, pg/vg ratios & flavors.

    Start off @ a low V setting and slowly work your way up until you find what you like or taste a hint of burn, if burnt taste occurs turn the power down a little.
     
Thread Status:
Not open for further replies.

Share This Page