I'm very happy with my joyetech eGo ONE Mega V2 and just started with the CLR atomizer heads.
I couldn't understand why the airflow on the CLR was so different from the CL.
After a closer look, I realised that the bottom hole in the CL is much bigger than the CLR's.
I replaced the bottom piece from the used CL atomizer on the new CLR. That improved the air flow a lot.
I replaced the coil with my home made - 4 windigs of Kantal A1 28ga.
This improved the CLR even more, it's now 0.90 ohm (I think, that from stock, it comes with about 1.2 ohm).
From the left, CL, CLR, my CLR with the bottom part from the CL:
I couldn't understand why the airflow on the CLR was so different from the CL.
After a closer look, I realised that the bottom hole in the CL is much bigger than the CLR's.
I replaced the bottom piece from the used CL atomizer on the new CLR. That improved the air flow a lot.
I replaced the coil with my home made - 4 windigs of Kantal A1 28ga.
This improved the CLR even more, it's now 0.90 ohm (I think, that from stock, it comes with about 1.2 ohm).
From the left, CL, CLR, my CLR with the bottom part from the CL:
Last edited: