1. Win Vaping gear! The ECF 15 Millionth Post contest

    We are fast approaching the 15 millionth ECF post and we have a contest to celebrate this huge landmark and amazing prizes to give out to our members! Head over to the official contest thread to see the rules and check out the prizes generously pledged by our registered suppliers on the prize announcement thread.

mvp2

Discussion in 'General Vaping Discussion' started by dooglez, Dec 9, 2013.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. dooglez

    dooglez Full Member

    Joined:
    Nov 10, 2013
    Location:
    akron
    does anybody know what the lowest ohm that a mvp 2.0 will fire
     
  2. DasBluCig

    DasBluCig Ultra Member Verified Member ECF Veteran

    Supporting member
    Joined:
    Jul 30, 2013
    Location:
    Chichester, NH
    The built-in protection circuitry is SUPPOSED to limit firing to ABOVE ONE (1) OHM.....
    However....I've read where some have been able to use coils as low as .7 ohms....NOT RECOMMENDED!!!
    If you want to go sub-ohm you'll need to use a mod with high-drain batteries (AW IMR 18650, et al)....
    And KNOW OHM'S LAW LIKE THE BACK OF YOUR HAND!!!!
    Back to the MVP v2.....I use 1.8-2.0 ohm coils that I wind myself with 32ga. A-1 kanthal wire on a 3/64" arbor...cotton wick...
    In a Protank 2/Mini....I find the vape incredible!!
    If you're not into winding your own....BE SURE to get GENUINE coils for the brand of tank/clearo system you have....
    Clones have a bad reputation of being DOA....the "genuine"s can be kinda hit-or-miss, too.. I find "Genuine" Kanger coils can vary as much as .2-.3 ohms in a 5-pack!!:( The main reason I started winding my own!!:D
    Good Luck!
    Happy (vaping) Trails!
     
Thread Status:
Not open for further replies.

Share This Page