Hi, ima newbie to this sit and i would love help with my picoproblem.. When i press fire button the screen shows "no atomiser" so i changed to a new atomiser btu themessage is the same "no atomiser" i need some help please.. thank you..
This is often (always?) because there is no electrical contact between the firing pin (inside the thread on the mod) and the atomizer (plate/pin inside the threads inside the base of the tank).
Maybe your 510 pin is pushed down. Maybe you need to inspect the 'inner' contact plate on the base of your atomizer.
What's your atomizer/tank?
The electronic processor in your Pico is not detecting the coil in your tank, hence it is giving you the error message "No Atomizer" detected.
This is likely the result of one of three possible scenarios:
The coil in the tank is not installed correctly inside the tank. The coil may be loose, off center, or too tight. It should fit "snug".
The center pin (within the threaded 510 connector) of the tank has become pushed into the tank, and will need to be teased back flush into the correct position to make electrical contact.
The tank's center pin is not making electrical/physical contant with the 510 center pin on the Pico. Often, if you overtighten the tank onto the Pico, it can push the center pin of the Pico down into the battery device and it will be unable to make electrical contact to fire the coil. Watch the below video for the fix.
Could be something as simple as you have a bit of dirt inside the 510, which is blocking the connection. I would try getting a tissue and giving it a good clean out.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.