1. Win Vaping gear! The ECF 15 Millionth Post contest

    We are fast approaching the 15 millionth ECF post and we have a contest to celebrate this huge landmark and amazing prizes to give out to our members! Head over to the official contest thread to see the rules and check out the prizes generously pledged by our registered suppliers on the prize announcement thread.

Protank 2 beauty ring/ base?

Discussion in 'Tanks' started by Carmigirl, Nov 1, 2013.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. Carmigirl

    Carmigirl Full Member

    Joined:
    Sep 6, 2013
    Location:
    Illinois
    Just received the above. Put it all together on my provape and the Beaty ring just sits there loose and rattles. Any ideas as to why? When I remove it and attach the protank directly without adapter it gives a nasty burnt taste. It's a 1.6 ohm....so much to learn!
     
  2. stevegmu

    stevegmu Vaping Master ECF Veteran

    Joined:
    May 10, 2013
    Location:
    6992 km from home...
    Try 2.2 ohm coils on the ProVape-1. the 1.6 may be a little too low for a PV-1 with a fully charged battery. I use 1.8 ohm on my ProVaris, but only vape at 2.9-3.3 volts. The PV-1 starts out at 3.7 volts, which is too high of power for a coil of that low resistance.

    The beauty ring is made for a ProVari, which has a larger diameter than a PV-1. Are you referring to a ProTank2 mini or regular? I use Tatroe mods bases on all of my PT2s, which perform and look much better than the stock ones. They also now have an adapter for a mini, which looks nice-

    Mini Tatroe Bottom Cap
     
  3. Carmigirl

    Carmigirl Full Member

    Joined:
    Sep 6, 2013
    Location:
    Illinois
    I knew it was going to have to do withe the resistance! Thanks so much for the reply!
     
Thread Status:
Not open for further replies.

Share This Page