Dismiss Notice
ACT NOW!! Stop the FDA from banning nearly ALL vaping products from the market! Support the "Cole Bill" now: CLICK HERE for details

Protank VS RBA Question

Discussion in 'Tanks' started by moumar81, Feb 10, 2014.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. moumar81

    moumar81 Full Member

    Jul 16, 2013
    Herndon, VA, USA
    I have been experimenting with RBA and been getting a lot of good flavors. On my rba, i been building 1.ohm micro coil and flavors on all my new fruit juices had been good. Before the RBA, I been using my protank with 1.1-1.4 ohm micro with cotton, with a menthol fruit juice and taste is good. And the new juice I got is all fruits and the flavors is not there with 1.1-1.4 ohm.

    Do you think 1.1-1.4 ohm micro coil is to low for protank? What is the lowest I should use for protank?
  2. Fenris4024

    Fenris4024 Super Member Verified Member ECF Veteran

    Mar 31, 2013
    Lubbock, TX
    In my pt/evod coils rebuilds, I tend to find most juices taste better in the 1.8 to 2 ohm range, plus, using a vv/vw device, this seems to give you the most "play" with how a juice will taste. Obviously your results might be different depending on the juice too.

    In my rbas I do tend to prefer a lower ohm though.


    Tapped out on a phone... I think
Thread Status:
Not open for further replies.

Share This Page