I want to get started with rebuildable atomizers and mods, but because I'm short on money right now I'm wanting to rebuild my Protank 2. I'm wondering if a micro coil built to around 1.4 to 1.8 ohms with 28 gauge kanthal would work fine on a ego twist?
Rebuilt Protank 2 on Ego Twist?
- Thread starter Kemplek
- Start date
- th_trl_thread_readers 0
- Status
I would recommend the 1.8-2.0 ohm range
make sure you have a multimeter to check the ohms (make sure you take into account the resistance of the meter leads - mine are .3-.4 ohms - or if the meter you have has a zero function make sure you zero it each time) and to check for shorts
Welcome to the forum
make sure you have a multimeter to check the ohms (make sure you take into account the resistance of the meter leads - mine are .3-.4 ohms - or if the meter you have has a zero function make sure you zero it each time) and to check for shorts
Welcome to the forum
Yeah I have a multimeter and how many wraps should get me in the 1.8-2.0 ohm range?
I've tried a few protank builds and found 30 gauge works best for me when installing a micro coil. Your experience may vary. LOL
Dakota Jim is correct on the target ohm to shoot for with your twist. IMO, their not meant for high amp draws and could damage it.
Sent from my iPad using Tapatalk
Dakota Jim is correct on the target ohm to shoot for with your twist. IMO, their not meant for high amp draws and could damage it.
Sent from my iPad using Tapatalk
Last edited:
That's the question, builds can vary slightly so just practice. I would think with 28 gauge, maybe 13? That's another reason I would recommend a smaller wire, the lower the gauge, the more the resistance.
Sent from my iPad using Tapatalk
- Status
Similar threads
- Locked
