At this point, I added some eliquid. It allowed me to push the wicks down into the chimney tube, but not "stuffed," which could block juice flow. Also, remember to keep the coil above the air flow chamber.
Checking the coil on the Ohm Meter. Shows 1.6 Ohms exactly. I wanted a 2.0 Ohm coil, and rebuilt the coil using a 3/4 wrap and got exactly 2.0 Ohms.
The remaining tubes are added, this day all metal, and then the top and mouth piece (drip tip) are added. The Kayfun is ready for juice now.
the top of the chimney is added, as is the first tank ring.
At this point, I added some eliquid. It allowed me to push the wicks down into the chimney tube, but not "stuffed," which could block juice flow. Also, remember to keep the coil above the air flow chamber.
The wicks are then trimmed.
The long ekowool 3mm wicks fed up the chimney.
First coil. This is a 3/2 wrap with 32 Kanthal. The base sits in a Siam Mods base holder. Notice the wick sits above the airhole. The leads are easily connected with the two screws.
Bill's Magic Vapor

At this point, I added some eliquid. It allowed me to push the wicks down into the chimney tube, but not "stuffed," which could block juice flow. Also, remember to keep the coil above the air flow chamber.

Leave a rating
Follow Add bookmark
There are no comments to display.

Media information

Album
My Kayfun
Added by
Bill's Magic Vapor
Date added
View count
261
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Top Bottom
Forums
Products
Vaping.com
Star Suppliers
Blogs
Menu