Search results

  1. BigLebowski

    mtbakervapor

    My iTaste SVD, cylone clone, and battery cases are in San Francisco. . . hopefully vapemail Friday.
  2. BigLebowski

    mtbakervapor

    iTaste VV is only $39.54 at Fasttech, that was fast. . .
  3. BigLebowski

    Small Form- Factor and specs needed to run a RBA

    Mechs offer little protection, you can buy a safe fuse but there is no regulation, meaning you get the full load of the battery and it will continue to drop beyond the safe level of a battery without warning. A regulated device will stop working before the battery gets below that safe level. If...
  4. BigLebowski

    RBA/RDA coil consistency

    Check this thread out, no sense in spacing out your coils unless you are into sub ohm builds.
  5. BigLebowski

    Just rebuilt my first coil! Yaaayyy!

    There is no turning back now, the first step in RDA's/RBA's.
  6. BigLebowski

    mtbakervapor

    His stand ups are hilarious, when he and his buddy Dave go out street racing and asking the cop for directions. I really wish he would come back to comedy.
  7. BigLebowski

    Just built my 1st MICRO-COIL!!!

    For me, 29g kanthal at 10 wraps is around 1.8 ohms. You should be fine with 10-12 wraps of 28g.
  8. BigLebowski

    mtbakervapor

    Every time I hear Yellow Cake I immediately think of this. . . I got some here, wrapped up in my special CIA napkin.
  9. BigLebowski

    Just built my 1st MICRO-COIL!!!

    There is no set resistance to microcoils, the point is to get the sub ohm experience without the risk, whatever tastes good to you.
  10. BigLebowski

    mtbakervapor

    Still sitting on my bookshelf, too much menthol initially for me. Waiting to see what it does in another month.
  11. BigLebowski

    Vaping for no reason question.

    I vape whenever I get the chance, I just enjoy it. It doesn't matter how/when you vape just as long as you aren't smoking. Your body will tell you when you have had too much nic, feeling queasy and/or light headed.
  12. BigLebowski

    Just built my 1st MICRO-COIL!!!

    I've never had an Evod or used their heads, I stay away from the plastic tanks. Been rocking the micro with them for awhile now and even when I get some extra heads for spare parts, I rip out the stock garbage and put mine in.
  13. BigLebowski

    mtbakervapor

    Sounds like it caramelized, I have had this issue with the sweeter juices in the Protank. I just turn the voltage down and dry burn the coil and replace my cotton wick after every tank.
  14. BigLebowski

    mtbakervapor

    Bummer, I was hoping to visit MBV while I'm in the Northwest in a few weeks but apparently their only location is just a warehouse. They are supposedly opening a storefront in September. Thought I would pass that along.
  15. BigLebowski

    mtbakervapor

    Boxcars pays 30:1, Yahtzee!
  16. BigLebowski

    mtbakervapor

    I'm not sure if it was intentional, but fair maiden was hilarious. The whole Ginger thing :tongue:
  17. BigLebowski

    Going Through heads like crazy

    What he said, it will give you the actual voltage/watts. Also, think about rebuilding your heads, will save a ton of money in the long run.
  18. BigLebowski

    Just built my 1st MICRO-COIL!!!

    Not sure about squeezing that many into a Protank, most microcoils are typically no bigger than 10-11 wraps but it doesn't hurt to experiment. Go big or go home, right.
  19. BigLebowski

    Buyers remorse no more!

    Another one drank the Kool-Aid :2cool:
  20. BigLebowski

    Just built my 1st MICRO-COIL!!!

    Too much cotton will choke the wick, it's better to go less. I lightly roll the cotton between my fingers and if it doesn't go through the coil without any resistance then I pull a little off and lightly roll it again. Cotton expands a lot when saturated with juice. I use the Protank post and...
Top Bottom
Forums
Products
Vaping.com
Star Suppliers
Blogs
Menu