Could be your taste buds, uncut Pluid has never seemed weak or muted to me. It does change flavor a little depending on setup but its always an In Your Face vape. Where'd you get the juice?
Is it smooth until you are almost where you want it then it gets tight? If so that is when the oring reaches the base, you can keep going and compress the oring until the pin is how you want it. If its rough the whole way you probably have it cross threaded. The threads are fine enough that you...
The center pin is adjustable. You need to take it apart and rebuild it. Can you take a pic of the 510 connection? Does the center pin stick out a bit? The further out it sticks the more airflow you'll get. That distance is determined by how far you screw the ceramic housing into the base before...
The insulators are way too soft in these. Also on one of mine, the rectangular piece that has the center pin and positive post on it, the corners touch the negative post when it's at either 45 degree angle. This makes for a dead short! I took it completely apart and put enough of a radius on the...
I think it's at least 50/50. As you pull it up in a syringe, the VG wants to "boil" while its under vacuum. I'm not sure at what percentage point this happens but I've only seen it on the higher VG juices.
Here are a couple crappy pics of my coil. It's 29g on XC132, 1.7 ohms. I use a screwdriver to wrap the coil it measures 0.078" so it's a little bigger than 1/16" but works perfect for the Nextel.
The feed hole is half way up the positive post and the air hole is high enough that I can have a...
That Provari will come in handy for checking the resistance of your coils! That's about all I use mine for nowadays. You should probably go ahead and order some of your favorite juice at lower nic levels. RBAs make that much of a difference, you'll probably be getting nic sick with your normal...
2.2 Ohm Coil, 50 Pack
This is a good price on pre made wires, limited choice of resistance though. And Kat, the Killer uses NR wire too, not sure about the Diver.
I use XC132 in my Cyclone with a micro coil at 1.2 ohms. Rocking it on the Reo Mini and flavor and vaper are awesome. I do have to dry burn it every day or so but that takes about a minute. Check out the microcoil threads in the RBA or Reo sections, you can use them on mesh too.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.