Search results

  1. markfm

    Help please!

    Sometimes just knowing that other people have been in your shoes does help. I went from pack-a-day for 37 years to vaping back when devices were a couple of watts, and 2 ohms was considered "low resistance" [emoji3] I needed 24mg eliquids, and kept some 30 or 36 mg to get me over craving...
  2. markfm

    Closed/Sold 129 Kanger 0.5 ohm occ Claptons and 2 tanks

    1. Never Used Kanger Protank 4, including RBA that also fits the Toptank mini. 2. Kanger Toptank mini. Used to test 1 0.5 ohm Clapton OCC head (#4 below), verify they worked well, then cleaned. The Toptank mini did not include an RBA. 3. 2x spare Toptank mini glass. 4. 129 Kanger 0.5 ohm...
  3. markfm

    Are you done stocking up?

    For me getting comfortable with mechanical mods, and protected bypass mods, was key (protected bypass mods, like the ehpro armor prime, provide low ohms and short circuit/reverse battery/low voltage protection, but do not have screens or advanced regulated mod functionality - they just pass...
  4. markfm

    Are you done stocking up?

    I couldn't resist getting 1 Max, $25 shipped using STAYWITHUS
  5. markfm

    Random DIY mixing and More

    My vc1 is tasting really good after 5 days steeping, so i decided to try a slight variation. Here are the flavorings used for a 125 ml batch: vc2: 5 Cap Van Cust V2 2 TFA VC II 2.5 Flavor West Dulce De leche 2 TFA French Vanilla II 2 TFA DX Sweet Cream 2 Flavorah Vanilla Pudding 1.5 FA cookie...
  6. markfm

    Comment by 'markfm' in 'Dvarw RTA Wicking Techniques'

    Can't wait to use these when my mtl fl arrives
    • markfm
    • Blog entry comment
  7. markfm

    Random DIY mixing and More

    My stock is until I'm 90 [emoji16]
  8. markfm

    Are you done stocking up?

    If you like a 0.3, keep an eye out for any sales on the Vaporesso gt cCell 2, a quite nice 0.3 ohm coil that fits the Cerberus and Hellbeast.
  9. markfm

    FastTech 8 Years Anniversary Giveaway

    Happy 8 years anniversary to FastTech! @Bovinia @FranC
  10. markfm

    Random DIY mixing and More

    Going to replace the regular thermostat at the same time? Apparently it's like a $9 part.
  11. markfm

    Random DIY mixing and More

    When you pull the drum, behind it you should see a pan with the heating elements. The thermal limit Fuse should be along the lip of the pan. It'll have two wires connected to its terminals by friction clips. It's held inn place by a tab on it's higher side, and a single screw on the bottom edge.
  12. markfm

    Are you done stocking up?

    I'm also a member [emoji3]
  13. markfm

    Random DIY mixing and More

    It looks like the thermal high limit fuse (aka high limit thermostat) can be checked with a standard multimeter, since it doesn't reset. Nice general writeup: How to Verify the Thermal Fuse Is Burned out on a Dryer Apparently the fuse is normally closed (continuity between the two terminals)...
  14. markfm

    Shinyitis Support Group

    Afraid I'm clueless on those. I did multiple tobacco eliquids years ago, still have the recipes, but for years now I've vaped non tobacco flavors. (Back in the day there were fewer choices. I took up DIY to get just what I wanted. I also did some things in both vg-free and pg-free versions...
  15. markfm

    NotCigs refugee thread

    These are my current ADV. I run 2 squonk setups, one with each. #s are in %. I mix a pint at a time of the vanilla, a cup of the lemon (condiment bottles [emoji3]) Van ADV 1 TFA Vanilla Swirl 1.5 FA Cookie 2.5 Flavorah Vanilla Pudding 3 Natures Flavors Vanilla Lemon ADV 1.25 Flavorah...
  16. markfm

    Are you done stocking up?

    I didn't receive the follow up email, for sure. It did forward me to the a USG site which looked weird at best, some kind of beta site.
  17. markfm

    Random DIY mixing and More

    So you use PM08X10085 duct? I'm lucky, our 20+ yo Westinghouse dryer has been pretty hassle free. Replaced a drum belt about 5 years ago, and the door insulator strip this year, but they weren't bad.
  18. markfm

    Random DIY mixing and More

    What's the model #?
  19. markfm

    Are you done stocking up?

    Aspire Mixx was picked up in Hong Kong by 4px on 8/26, while the dvarw mtl fl RTA was handed to airline transport in Shenzhen on 8/28 (US Express e-packet). I wonder which one will escape the shipping black hole and make it to the US first [emoji3]
  20. markfm

    Are you done stocking up?

    I clicked the submit comment button, though not certain it actually got posted (too bad if it didn't - it was a custom comment).
Top Bottom
Forums
Products
Vaping.com
Star Suppliers
Blogs
Menu