The thread rings are small and very light make sure they didn't get tossed with packaging......a thanks for the tubes is in order and the rest have no idea...lol.
If it whistles just pull the tip out a little should stop or switch screws..I think its from the air flowing past the positive screw and bottom of tip to make the whistle...sucking way to hard has never been an issue......lol
Yes it is I do a 4/3 wrap on 40mm mesh with that setup at roughly 1.2ohms and chokes me out with pluid....but love it reminds me of high school....lmao
That sucks...............bounced mine of the tile floor on accident with no protecter on and tank busted but tip went flying and landed on carpet...not sure if that was best option yet......tank prob easier to get than tip.. aluminum and cap help up well with no damage at all.....
I have 1 on top and 1 on bottom so either they were just put into machine any random way ans doesn't matter or got lucky and have 1 of each ,,but I have looked at both mine to just see differences and that's all come up with ....however I could have both the same and just wasting my rime looking...
OK looking into the 1st 3 pluids diff from others if there is how bout the ? Of 30 on some reads with wick on top of atty and a others with wick on bottom of atty ???
Ya that's what its doing for sure . Not wicking well so normally 3 o'clock works well but gets a little to much and does what you say on wick.......is this a prob? Will it change taste? Is there a fix? Is kind of hoarse but just switched to full strength and figured that was why....used...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.