Search results

All's well that ends well here, too -- called and talked to someone on the phone. The problem was that I didn't specify "what size bottle" I wanted of the juice I was ordering. Well, that was a little confusing, because basically I had hit "Reorder" from the last time I ordered those flavors...

I appreciate the issues that retailers can face with credit card charge-backs and so on regarding fraudulent use of cards. However, I don't know what the answer is for those of us who don't and can't receive mail at our residence addresses and must have a PO Box for everything except UPS and...

I hope I'm not going to run into the same type problem with an order I just placed -- store I've been doing business with just about every month for over two years. Address on my driver's license is the street address of MY home, but I've been living with my elderly mother and caring for her...

Windows XP

Downloaded it, when I try to run it I get this message "Not a Win32 application". Any suggestions?

I don't have anything that uses paired batteries, but I'm curious: do those of you who do have paired batts mark them somehow so you will know "this batt goes with that batt"? Maybe give them names and write "Jenna loves Joe" and "Joe loves Jenna" on them?

What about a pouch hanging from a chain or cord around your neck, and dropped down inside your clothes? You might want something less heavy than a Provari, and I'd choose a pouch or case that fastens shut so my vape didn't stand a chance of falling out.

If you measure and cut carefully, you should be able to make a cut in the sleeve so that the LED feature will show.

If you have an AR mech mod, just point that at them.

My pinky on that hand has a little bit of nerve damage, not enough to notice unless I'm trying to press that bottom button. Magnets are a good idea, I'll probably get some and give it a shot.

I do need to get used to pushing the button at the bottom for my vape on this type of mod. Guess the third finger of my right hand will be getting stronger from the resistance exercise.

aHA! I looked more closely and by golly you are right, there WAS another little ring there! Seams were very hard to see on the rainbow color. So I took it off, tightened up the pins at both ends as far as they would go, loosened the top pin a little bit to allow the atty to screw down into...

Not practical, nope! Thanks for the info, it's something good to know.

No, unless it's the "beauty ring" that I mentioned. The only short ring that came with the mod is this "beauty ring" that just slides on over the top of the 510 unit. That 510 unit has an O-ring set in under the very top of it, and this "beauty ring" covers that. No threads in this "beauty...

I found this information about using a Nemesis clone mech mod, and it says this: •Adjustable Firing Bottom - Bottom Contact connects with the battery inside of the Nemesis, screw in to adjust for the battery size. It’ll also double as the On/Off switch. •Bottom Rocking Ring - To lock the...

I've got the 2 sections of the rear left in Izan's post (Thanks, Izan), plus the section with the 510 -- that section has a narrow press-on ring that seems to be a beauty ring with 2 vent holes (no threading on this beauty ring thing). And the bottom base with the switch and spring. If I put...

Well, it's *slightly* below the level of the insulating ring. If I tighten the pin/screw, the insulating ring and the brass threading below it also move downwards and the level of the pin to the level of the insulating ring remains the same.

By pin do you mean the thing that I am calling a screw?

All right. I played a bit with the different parts of the tube, and managed to determine which pieces would allow for the battery to come closest to both the top (510) end and the bottom (switch) end. I did have to extend the screw at both ends somewhat in order to get contact at both ends of...