Search results

I became interested in the zenith after getting my Stillare. The Stillare is a great atomizer and very high quality. My only issue with it that left me desiring something more was the flavor. The chamber is reduced but it's still rather large. I wanted an authentic atomizer that had very few...

I've just acquired a 100ft roll of 24 gauge and my new Cartel Stillare V2 which I love! But this was my first time using 24 gauge. I did a 6 wrap on a 3/32nd drill bit, dual coil, and it metered at .26. This is a bit lower than my normal .32-.37. Do many of you use 24 gauge regularly? I'm...

I have just purchased a copper EhPro Caravela With no logos or anything on it and it came with the floating pin in the top already. It also came with an extra white plastic piece, 3 different size screw positive pins and an extra switch spring. My trident 2 will not for flush with the floating...

I normally do not do this as I used to feel that it simulated flooding on certain decks. When doing a micro/macro coil that is NOT centered with the center post, I cut the side closest to the edge of the deck just short enough to tuck back toward the negative post and then leave enough on the...

I've come across a few of these scenarios. It frustrates me when I hear stories of a B&M that builds RDA/RBAs for inexperienced people that are either dangerous or poorly built. The one case that recently fueled this rant is one of a shop that has no employee over the age of 21. The one...

On my IGO-W, the centre post likes to get pushed down/spin when I tighten it down. I'm not tightening it with Hercules strength or anything, just trying to make a good connection with my 26g duals. Has anybody come up with a remedy for this sort of issue?

So I used to work at a little B&M in WNY. Used to meaning I quit there yesterday because of a few reasons. Actually a bunch of reasons. Unprofessional, grandiose, belittling owner to keep it brief. Now the one major issue was her outlook on Rebuildables and Mechanical devices. She thinks...

On my IGO-W, I've built a side by side quad coil of 28gauge, 8/9 wrap, 1/16th ID metering about .31 ohm. My problem is wick placement. As of now, I have two tiny strands of cotton lightly twisted with the pointed end barely reaching the edges of the well and the fatter part going around the...

I have an EHpro EA mod, cleaned thoroughly and greased all necessary areas with dielectric grease, an IGO-W, and Sony VTC4's. I built up a quad coil with (4) 26 gauge kanthal, 8/9 wrap around 1/16th bits. Ohmed out around .22 Now I understand the whole "anti-extreme-subohming" but I have...

Been a long time lurker here for a while. I've been smoke free since 12/24/13 and loving it! As of late, I have been rebuilding/subohming/dripping primarily but I still love my regulated devices. This place is a wealth of knowledge to both the inexperienced and the experienced. I look forward to...