Search results

Just grab Sanyo 20650 batteries and use rubber band, spacer, or even tape. They are very solid performers.

MaxAmps LiPo 800 3S 11.1v Heli Battery Pack This should work. Just make sure to adjust your evolv settings. Hobbyking has a 950mah one but I think max amps is more trustworthy.

The faceplate comes off and has the board behind it (two little star keys above the button) If you can solder then replacing the board shouldn't take too long.

The Kennedy 24 and greater require 2.5mm or greater sized coils. The way the airflow works means a Jetstream gets created at the inside edge of the bottom air holes so place the center of your coil just above that spot to interfere with the jet stream. Because of the length of the top cap and...

Just set mine up and in the middle of my morning commute with the recurve in hand. Yeah. I like this mod. Dig the weight. Good ergonomics. Compliments my reload x rda with some 0.16 aliens. The button is sublime. The looseness of the door out of the box seems like an oversight but it's an easy fix.

Looks like a solder point failed to the 510 of a lost vape halcyon. Obviously out of warranty. Unfortunately my soldering skills leave little to be desired and so if anyone knows of somewhere I can send it to in California the information is much appreciated. I live and work in East Bay so the...

I did some 2.5mm 3x29ga ni80 wrapped in 38ga ni80 fused claptons, 0.19ohm coils. At 92 watts it's a brilliant vape.

Whichever can afford you hemo mods? Seems such a personal decision to bring to such forums. I disagree with Psihoza. Make all the money and gain all the experiences you can while young (and make sure to save and invest) so that you can pick from opportunities and do what you want later. But...

So I wanted to chime in about this rda. I've experimented quite extensively and I'm pretty impressed with this rda. Believe it or not but the build that seems to draw the best flavor and texture is a simple 3mm 9 wrap 24ga ni80 round wire build. On a regular mod at 80-90 watts it's excellent...

It's all screw hole alignment. Misfires, switch rubbing.. etc.

Take apart and clean. Now put it back together, but screw your atomizer into the 510 while doing so. This, I've found, helps keep everything aligned and gives you the best chance of catching misfires. I've noticed a rubbing feeling on the switch and this is how I avoid that. It also helps in...

Do spaced coils get hot spots?

get one when you can. Hopefully someone develops a series kit for the ds as the option would be great. I am considering buying another one although that may be Overkill.

Blow it while upside down to clear, making sure to put paper towels or napkins around the air for what comes out. Use dish gloves to grip while opening. I've had some luck using sandwich bags for that grip needed. If you can't even get a hold of those use a USB cable as a loop wrench.

Start saving your money. You are gonna need it.

because,why not

cheap setup. Cloned notoy. I was looking for a more flavor centric setup that I could use 20amp batteries with for longer battery life. Just need to sand down the 510 but it's seriously a solid, solid, delicious vape.

Often a sweet tooth is due to dehydration, right? Vaping dries out the mouth requiring one to sink more water... So... Maybe?

Question for those that have ownership. Is the insulation also on the positive internql face of the cylinder?

I, for whatever reason, feel a need to point out that I'm not being contrarian. I just think your approach is garbage.