I've personally never had any issues getting my orders fast from GP. I'm in Mid-Missouri and stuff seems to ship next day, and show up in 3 business days. Can't ask for more than that!
Spliner
I have a couple of the OKL series laying around that I have yet to make a mod with; seem to work about the same as the OKR or TI series switching regs. You can adjust them over 5.5v but you'll probably fry them over time.
I have a 2xAA 5v mod using a PTN04050C booster.. just use 2 tantalum 100uf caps on the booster, run the output through a 3A horn switch to the atty connector, put the PTN04050C below the horn switch and use AW IMR14500 batts. Works sweet, up to 4h run time for me on each IMR14500 batt. Under a...
One of my favorite mods (goes with me everywhere) is a 2xAA box with a PTN04050cad boost using an AW 14500 Protected Li-Ion. Reads constant 5v without a load and drops to 4.8v under a load. I get decent run time out of it, and use 3.0 ohm cartos from Boge with it. Love that little mod.. its a...
I'd have to agree with everyone else. Use a standard 510 atty (by standard I mean 2.5 to 3.2 ohms) or cartomizer on your 510 models. Anything lower than 2.5 ohms will drain the battery too fast, and likely won't work well with a 180mAH 510 battery. The closer you get to 2.5 ohms the warmer...
Congrats to the OP for entering the fun world of DIY! I've been mixing my own e-liquid for a little over a year now. Typically I buy nicotine base in quantities up to 250-500ml at a time these days, PG and VG by the boatloads as well. Flavorings.. I don't even want to think about how many I...
I use LR cartos from Boge and they last me about 1-2 weeks. I can fill them with 30-40 drops, vape on them a few hours and add a half dozen to a dozen drops and continue vaping. It really depends on the e-liquid you are using though. For instance, anything with banana flavoring or VG will...
PG is an irritant, its what gives e-liquid that throat hit we all were looking for in a replacement to analog cigarettes. Like others have mentioned you can try VG based e-liquid. It is thicker, and will produce more vapor than straight PG, but it is less irritating (and has less of a throat...
I gave up using Trustfire/Ultrafire 14500's with a 4050 booster. I did however have some better luck with an IMR 14500 batt. I seem to get 2+ hours of vaping out of a single IMR 14500 with a 4050 boost, but I don't chain vape it. Seemed like the Trustfire/Ultrafire batteries would kick in...
I personally just want a very small low voltage cutoff circuit for a single high drain IMR battery. I'd be really really happy to find one. Overcharge is never an issue with them if you use a good charger, but over discharge is always a concern. Nice thing about using them with a boost is the...
Lol classic. I'm usually not around when my mail person gets there in the mornings but you can bet I'm digging in the mailbox at my lunch break. Hate it when they slack off and come in the afternoon! lol.
Spliner
You'll find a lot of us "carto drip". In my opinion it keeps the cargos nice and wet and makes them last longer. It works especially well if you are using lower resistance cartos. I remove the plug and replace it with a drip tip. Then after baling a while I add 5-10 drops, replace the tip...
Welcome kapla, you are not alone. I do believe this is my first post as well. Been reading these forums for quite some time just never posted. I figured it was about time to get started since I seem to gravitate to this forum almost daily for mod and DIY info.
Spliner
I'm not sure I saw the post you're talking about, but here's my take on it if you want it:
1) The carts sometimes leak. Your husband (or boyfriend, I forget which) posted that the carts were sticky on the outside. This happens, its not always pleasant, but as you work more with e-liquid...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.