Search results

Does anyone know of the proper oring size for both tobeco clone orings? Sent from my iPad using Tapatalk

Upto how many degrees and joules can the 0.15 coil run? Sent from my iPad using Tapatalk

Just a quick help please. I have been using the crown for a couple of months with the 0.5 ss coils with no major problems do far. Tomorrow I will be trying the included nickel coil with tc control on sigelei 150w tc. I have never used the mod in tc mode before so I would be greatfull if you...

I can confirm that they are original or at least they look exactly the same as the one I bought from a local store. Sent from my iPad using Tapatalk

I did get one from fasttech just yesterday and the marking has nothing to do with the one in the photo. It actually has the exact same marking as in the uwell website. Sent from my iPad using Tapatalk

Any good video on how to properly prime these coils available? Sent from my iPad using Tapatalk

What is the recommended watt range for the 0.50ohms SS coils? I am currently running them at 50watt but I was wondering up to how many I can go. Sent from my iPad using Tapatalk

It is indeed the sx330 chip. Thanks a lot for your assistance. Sent from my iPad using Tapatalk

Stupid me!. No I did not install the second battery. I will just try that. Thanks. Sent from my iPad using Tapatalk

Still nothing. Just to make it clear I am talking about the 150watt tc sigelei. Sent from my iPad using Tapatalk

Hi. I just tried this and it does not seem to work. I just installed one battery, kept the fire button pressed, but the display doesn't come up. Any thoughts? Sent from my iPad using Tapatalk

For those who have tried different setups, which is considered the best with 26awg wire and 2.5mm dril? Currently i am running 5 warps at 0.7ohms and i am wondering if i can get better results with higher onms.

I am having a very hard time trapping 26 or 24awg wire under those tiny screws and I always have to turn the wire twice around the screw, thing which is a little bit difficult to do. Am I doing something wrong? In all youtube videos I've watched the reviewer manages to trap the wire with just...

I received the M1.6 x 3mm replacement screws but unfortunately they don't fit properly. It seems that the base holes have been enlarged by trying to screw a little harder than normal. I wonder if M2x3mm would be a better fit. If not then it seems that my two Lemos will remain in the drawer.

What can I use to substitute Karamel INW?

Where can I find the recipe for venus clone by papillon61? A search within this thread didn't give any results.

Same here Redbellie. Up until now I had bubbles after every draw but also had floating and leaking. I always did cut the cotton to just touch the deck. Today however, i wicked and put on the first part of the chimney and cut the cotton at chimney height. I then tucked the cotton inside making...

I am looking to buy from ebay.uk as Amazon does not ship to my country Cyprus, but thanks anyway.

I know it has been posted before, but has anyone bought and used any replacement screws for the Lemo 2? Is the correct size M1.6 x 3mm? I am thinking of ordering this but I am not sure if they are the correct ones. Any help is much appreciated. M1.6 M2 M2.5 M3 A2 STAINLESS STEEL SLOTTED CHEESE...

Same thing here. Will it be supported on tapatalk later on?