0.08 ohm coil build

[s0uthstar]

I have a wismec reuleaux & i was wondering if there were any batteries out there that would handle a 0.08ohm build safely (dual transformer nichrome & kanthal) ?

 

[KentA]

No.

 

[KenD]

I have a wismec reuleaux & i was wondering if there were any batteries out there that would handle a 0.08ohm build safely (dual transformer nichrome & kanthal) ?

The amp draw on vw mods is determined by the wattage and battery charge level, resistance doesn't factor in. With 20 amp batteries you can go close to 180w with the rx200, whether the resistance be 0.08 or 1 ohm (assuming that we keep within the mod's voltage limit).

Sent from my M7_PLUS using Tapatalk

 

[sonicbomb]

The RX200 has a 0.01 ohm lower limit anyway so no. Like KenD said ultra low resistance coils are not required or even desirable for regulated mods.

 

[Lucas Rong]

^There is no point building that low on a regulated device. Just add one or two more wraps to you coils. Adding surface area an increase flavor.

 

[Jim_ MDP]

The RX200 has a 0.01 ohm lower limit anyway so no. Like KenD said ultra low resistance coils are not required or even desirable for regulated mods.

The DNA Reuleaux might, but I think the RX is a touch higher. 0.05 maybe?

 

[juicynoos]

I have to agree with Lucas here, then again, even if you can doesn't mean you should! Just add some wraps so that you can even dry fire them safely to get the hot spots out. Always build allowing for a safety margin with both your battery's and mods. You might just save face/your face.

 

[Robert Cromwell]

Having trouble finding an RDA that will accept 12 ga wire....

 

[sonicbomb]

I just reread this thread and realized I misplaced a decimal place, the RX200 has a 0.1 ohm lower resistance limit.

 

[SLIPPY_EEL]

Having trouble finding an RDA that will accept 12 ga wire....

I bet i could recommend a few!