0.35Ω - 0.4Ω Dual Nano-Coil Build on Magneto

Status
Not open for further replies.
Don't have pics, will upload if wanted...
28g, 6 wraps on each, plenty of organic Triple-OCD™ boiled cotton

Just wanted to ask if i'm safe around 0.2 ohms or even 0.1, even though my sweet spot is at around 0.4 ohms, because I want to build a super low ohm build just for the hell of it... I know what the ohm calculator says, but I'd rather ask first.

Also, why does my Magneto have a Spiderman logo on the button... I understand it's Chinese and called the "Magneto" but aren't there laws against this? Not that I care, $30 was a steal IMHO...

VTC5's - SS Magneto - IGOW drilled to 2.4mm
Using my Vamo v5 to read ohms and battery voltage until I get a dedicated one
 

State O' Flux

Vaping Master
ECF Veteran
Verified Member
Jul 17, 2013
4,844
4,993
Seattle
Just wanted to ask if i'm safe around 0.2 ohms or even 0.1

If you do the OL math, you know that the current drain doubles from a true 0.2Ω, down to 0.1Ω. The drain at the former is within acceptable CCD limits for a VTC5, while the latter - although within the pulse current drain limits - is not.
If you don't know what a PCD rating is - or trust the advertizing to be consistent (or even truthful) - then you might be better off sticking with your "sweet spot".

The accuracy of your Vamo - actually, most ohm meters in a similar price point - becomes highly suspect as resistances decrease... with readings being more a hopeful approximation than factual.
 
Not to mention the fact that it only reads to tenths so it could be anywhere from .30Ω - .39Ω
Plus I didn't really trust the Vamo to begin with... I'm using it more to guesstimate figured my coils wrapped around a paperclip measured on my friends sigelei @ 0.1ohm per coil so I run with that and check it with my Vamo...
Yes it is within the limits of continuous out, however my problem lies with the burst out which I'm not entirely sure whether it uses capacitors or what not that it matters... But I just don't know if it's burst capabilities are either 5 or 10 seconds or even more... That's my only issue, as I take 2-5sec inhales
 
Status
Not open for further replies.

Users who are viewing this thread