After searching and reading here, I've learned that my MVP 2 has a max output of 3 amps when it's fully charged at 4.2v. I read through this post (awesome, btw, from what I could understand) and, after trying my hand at wrapping micro coils with both 28 and 32 gauge Kanthal on a 1/16" drill bit I finally wrapped and wicked one with an organic cotton ball that is performing great without flooding or dry hits. (The first 2 wicks I must not have done properly.) It's the 28 gauge wrapped 10 times around the drill bit.
The 1.3ohm was first shown with the MVP's checker but, to be absolutely sure, I pulled the coil back out and tested it on an ohm meter and it read 1.32ohms. In that thread I linked above, the math shows that the amps on this coil with my mod fully charged would be 3.23, unless I messed up. And, from what I've read after searching, that should make the mod downgrade(?) automatically to 3 amps even.
Bottom line, I'll throw the coil out in a heartbeat if it's too low for whatever watt setting I use so my question: is this coil safe to use on this mod? And, is my math incorrect based on that thread that I should be getting the same amps at 9 vs. 10 watts? I'd swear I get better taste and vape at 10/10.5/11 but the brain is a funny thing.
The 1.3ohm was first shown with the MVP's checker but, to be absolutely sure, I pulled the coil back out and tested it on an ohm meter and it read 1.32ohms. In that thread I linked above, the math shows that the amps on this coil with my mod fully charged would be 3.23, unless I messed up. And, from what I've read after searching, that should make the mod downgrade(?) automatically to 3 amps even.
Bottom line, I'll throw the coil out in a heartbeat if it's too low for whatever watt setting I use so my question: is this coil safe to use on this mod? And, is my math incorrect based on that thread that I should be getting the same amps at 9 vs. 10 watts? I'd swear I get better taste and vape at 10/10.5/11 but the brain is a funny thing.
btw tobeco kayfun is awesome. 
