100% VG + Cotton

[Kuljit]

I haven't had Boba's Bounty since I first started vaping and was thinking about ordering some just for kicks. I started exclusively using a Kayfun L+ clone with sterile rolled cotton though, and a friend told me that this juice will reak havoc on coils and cotton wick alike. My questions are, does anyone vape this percentage in this tank? How long before wicks and coils have to be replaced? And is there an issue being as thick as it is traveling through the channels? I don't mind replacement once a day, but if it's just a big hassle I don't want to bother.

 

[Keynith]

I have usef other liquids and you have to wick it right to avoid dry hits. I think in another thread someone said they cut the cutton so it barely touches the deck and that avoided the issue. I gave up after multiple tries and just diluted it down with some pg.

Sent From My Galaxy Note 3

 

[Grrrr]

I use BB in my kayfun, it will gunk up your coils and cotton pretty quickly i generally try to change the cotton every few days but sometimes I leave it for a week if I'm too busy, never had a problem with wicking, I think less cotton than usual helps with the thicker juice. I guess just play around till you find the set-up that works best for you.

Sent from my SGH-T999 using Tapatalk

 

[ConConCon]

I have been using a KFL+ Clone and as everybody has stated previously you want to cut the cotton and SPREAD it out over the side wall so that all the ends are BARELY touching the bottom deck. Next time I rewick I'll try and remember to take a picture and update this thread, should be sometime tomorrow. It will almost look like a concave cut due to the outside being spread out diagonally to the outer preimeter of the bottom deck.
I have been using a high VG juice and have only had a problem with it flooding once, because I cut the cotton too long. It is a bit unforgiving if you cut it even a little too long.
Just keep trying and you'll get it.

 

[tw33k]

I've used both Bobas Bounty and Gorilla Juice in my 2 full-sized Russians for months. What I learned is that I need to use a 2mm id coil as the 1.5mm id was giving me problems. Since I made the switch, I've had zero problems. I cut the cotton so that it's just touching the deck and I keep it pressed against the wall between the upper and lower decks. I also tightened the air-flow a bit. This has produced the best vape I have ever had. No dry or scratchy hits just a fully saturated vape with loads of vapor.

 

[Kuljit]

Sounds promising, I may give it a shot. Thanks!

 

[billybedford]

Using a coil wrapped on a 3/32 drill bit and cotton in my kayfun with boba's bounty. been using it for a week and still going strong. Agree with making sure cotton ends touch only sidewall of deck raised area.

 

[GeorgeWachsmuth]

I also make slightly larger coils and ease up on the cotton with all vg liquids. No problems. I prefer higher vg in my Kayfun Lite.....