150 watt box mod with internal battery or charging capability

Status
Not open for further replies.

EvilGenius

Super Member
ECF Veteran
Verified Member
Dec 13, 2014
501
177
nj
anyone know of one that exists? I want a box mod that can go up to 100-150 watts but want one that has internal batteries that I can charge via usb cable or ac adapter

I was looking at the segelei and ipv3/4 but I don't want to change batteries

the reason is I travel sometimes for my job up to 2-3 hours and I don't want the hassle or danger of changing batteries while driving
I want something I can vape on for a couple hours without worrying about replacing the batteries

I sub ohm at .2 ohms and bought the arctic tank .2 ohm coils specifically for this reason

thank you

p.s. I found this: MEGATRON 260 watts 5400mAh box mod uses ac adapter to charge but looks really weird and no one has tried it yet so I'm a tad skeptical
 
Last edited:

sonicbomb

Vaping Master
ECF Veteran
Verified Member
Feb 17, 2015
8,362
23,817
1187 Hundertwasser
Jeeze, that thing looks like a claymore mine...Probably equally dangerous too.

3urTgDt.jpg


 

CoilinTrouble

Super Member
Jan 17, 2015
320
261
Lebanon, Indiana
Even of you vape around 150 watts theres no way youll completely drain two 18650 batteries in 2-3 hours. I usually use my Sig 150 around 0.4Ω around 50watts and it lasts me damn near all day chain vaping, but even when I have gone deep sub ohm and vaped around 130-150 the batteries still last me around 6-8hrs. I have a few internal battery mods but I feel its a bigger pain than just having a spare set of batteries around. The IPV3 and the Sigelei 150 both give me almost identical battery life but I could never picture myself draining two 18650 batteries in 3 hours...
 

EvilGenius

Super Member
ECF Veteran
Verified Member
Dec 13, 2014
501
177
nj
ok because when I sub ohm at .2 ohms on one fresh 18650 sony vtc4 battery I go through one in 20-30 minutes of chain vaping, so I figure 1 hour with 2 in a box mod but in any case, you also have to replace the batteries in the ipv4, I just checked, the only major difference I see so far is a magnetic door instead of screws
 
Last edited:

Oberon75

Ultra Member
ECF Veteran
Oct 26, 2014
1,771
1,382
Roseville, Mi, USA
I thought the ipv4 had this worked out? I think you need an ac adapter as it wont charge via usb.
Either that or it will have a parallel option as well since you don't need even close to 100w for temperature control. USB charging might not work, running your batteries in a series.

Sent from my HTC One M8 Harman/Kardon edition
 

CoilinTrouble

Super Member
Jan 17, 2015
320
261
Lebanon, Indiana
Still despise the IPV's battery springs. Tears the heck up outta my battery wrappers. Yeah that screw on only door is a big turn off from the IPV3 as well...And as far as draining your battery goes of course in a mechanical when you use battery power your voltage will drop and youll get less power out of your mod. In a regulated mod like the IPV or the Sigelei 150(my fave of the bunch), you get consistent voltage to the last drop. I would suggest a Buzzbox Raptor 120 as well, amazing chip and great customization options, its outta the budget for alotta ppl and it takes time due to them custom making your mod...
 

USMCotaku

ECF Guru
ECF Veteran
Apr 25, 2014
11,877
45,735
California
Look at a vapor flask with temp control, you might find you don't need as many watts as you think.
On the other hand, I use a variant. It goes to 260 watts. Doesn't have USB charging, but it uses li-po packs. I get a solid 2 days of vaping on it with a 1200 mah pack, when I get about a half a day out of a 2600 mah Imr battery on the same atty at same wattage
Sent with one hand, the other is busy vaping.
 

USMCotaku

ECF Guru
ECF Veteran
Apr 25, 2014
11,877
45,735
California
guys, I don't want to have to replace batteries... I want to be able to charge it like the istick or mvp


You are pretty limited then, if you want that high of wattage. May I ask why it has to have USB charging? Have you looked into the alternate option of using a charger with a Mobil adapter? That would help open up mod options
 

TorontoOntario

Ultra Member
ECF Veteran
Aug 13, 2014
1,008
589
Canada
Your extremly limited then with what you can get. I cant even think of a mod to do everything you need. I would get a Vapor Flask and top it with an atty with a higher build. I love to super sub ohm but you can get an amazing quality device and have USB if your willing to only have 40w and in turn probally build higher. I run a Quasar with a .5 twisted 28 gauge single coil on my Flask and it has some of the most intense flavor I have experienced. If your after clouds well then I can't be of to much help.
 

USMCotaku

ECF Guru
ECF Veteran
Apr 25, 2014
11,877
45,735
California
as stated I don't want the danger and/or hassle of replacing batteries while driving for my job, I bought the arctic tank for this purpose so I don't have to drip and drive (it sucks by the way!)

I have the leaf istick 50 but it doesn't cut it when using .2 ohms


Try the kanger sub tank, with the new nickel occ heads, on a vapor flask.....
 
Status
Not open for further replies.

Users who are viewing this thread