.18 ohms on Sigelei 100w

[Kaezziel]

So i should just not use the pre wrapped ones and make my own?

You'd probably be better off... you'd be surprised at just how well a dual coil at 1 to 2 ohms total would perform on the sigelei... I'd suggest going no lower than 0.5 ohms total for sure.... any lower than that and the only thing you're really accomplishing is draining the battery faster than you really need to...

 

[tj99959]

I would suggest starting out with only one coil to start with. Dual coils quadruples the potential problems you might encounter. I would also suggest learning how to build a +1 ohm coil before you try a sub ohm coil.
+/- 0.1 doesn't amount to much on a 2 ohm coil, but it's double or nothing on a 0.1 ohm coil.

 

[Kaezziel]

I would suggest starting out with only one coil to start with. Dual coils quadruples the potential problems you might encounter. I would also suggest learning how to build a +1 ohm coil before you try a sub ohm coil.
+/- 0.1 doesn't amount to much on a 2 ohm coil, but it's double or nothing on a 0.01 ohm coil.

Very true... and a very good point! I didn't think about suggesting starting with a single coil... my first coil build was dual coils on a dripper... but then again, I'm smarter than everybody else

 

[foraben]

Ok thanks guys im gonna try building a 1 ohm single coil first, and then later on try dual coil

 

[Rwb1500]

Ok thanks guys im gonna try building a 1 ohm single coil first, and then later on try dual coil

I find that I actually like single coils better. They're easier to build, easier to wick correctly. With dual and quads you're only multiplying the difficulty of doing things correctly. And trust me, building drippers isn't always plug and play. It takes a little practice to get it right. Hell, it took me 4 or 5 months of trial and error to get a really well performing dripper.