Heeeeeyyy everyone, I'm currently working with 22ga kanthal wire and an wondering what some better basic builds would be to throw some clouds!!!!
22ga kanthal wire basic builds for a noob?HELP!!!
- Thread starter LikelySplash710
- Start date
- th_trl_thread_readers 0
- Status
4 wraps on a 3mm mandrel should give you something in the .3ohm range.
When I was using my Velocity V2 rda more consistently I would always build with 22G kanthal wire. In fact a have a build that is still good in my RDA and the cotton believe it or not is good still because I was using a lighter juice. On a 3mm bit or coil jig wrap a dual coil 6 wraps each coil with that wire and it will ohm out at just about .21 ohms. I usually went up on this build to 65 watts and this is how I found my sweet spot. Believe me if youre looking for clouds you'll get great clouds. What's best I that it's a simple coil build and we're not dealing with the fancy wire. You mentioned kanthal and I just want to point out that this build on 22G wire other than kanthal, for example nichrome and ss would have the ohms very low so stick with kanthal for this build.
My favorite 22g build is a 7 wrap on a 3mm. It just works for just about any setup you have and the flavor and dense vape it produces is delightful. Also doesnt seem to get gunked up as bad as other builds.
Maybe a dumb question but if my redo it has two voltages at the same on it that someone told me are my individual batteries do I add them to together? They both say 3.6v I build a dual 10wrap of 22ga kanthal is that safe? Mildly confused
50-70 depending on the juice and mod.....more bakery a flavor the more warmth i want so i might even do 80.
- Status
Similar threads
