3 blinking blue lights?

[dnrtn2342]

I was using my 306 atty and drip tip, when I turned the batt on I got 3 blinking blue lights, so I thought maybe batt was dead so I attached a fully charged ego t batt and got same thing. Maybe atty is dead? I put on tank to both batts and works fine so this must be issue? Any ideas?

 

[Underwhelmed]

Sounds like your atty to me. Not sure if it just needs to be cleaned or if it has a dead short.

If you have a multimeter check the base of the atty to see if it's shorted using the ohm meter.

 

[bsidb]

ohms to low maybe?

 

[dnrtn2342]

Well I half azz cleaned it the other day, im still a newbie at this so I prolly screwed it up, it worked fine last couple days. Ehh whatever ill just buy a new one

 

[RichardV]

I have had this with my KGO and found that sometimes it was caused by the center post on my cartomizer or clearomizer that had been pushed down not making good contact with the center post of the battery. After lifting the post on the cartomizer or clearomizer the problem was resolved.