i just got my first LR 306 atty and a black plastic drip tip but the drip tip is so loose that every time i take a puff it pulls off!!!! it wasnt like that when i first got but i have only had it for two days!!! is this normal????
306 driptip problems??
- Thread starter lowcashvapo
- Start date
- th_trl_thread_readers 0
- Status
I've never had that problem before--could be a "defective" tip. Have you contacted the place you got it from? Maybe they will send you a replacement tip? If not you could get one with your next order, most vendors sell them. Sorry I couldn't be more help maybe someone else will chime in
i just got my first LR 306 atty and a black plastic drip tip but the drip tip is so loose that every time i take a puff it pulls off!!!! it wasnt like that when i first got but i have only had it for two days!!! is this normal????
There are two reasons why this probably happened... one is heat stretches the plastic over time especially when in combined with number two... two pushing the tip on too hard (which can break hard plastic tips for 306).
while i hadn't thought of reason one before i know that it isn't reason two i learned my lesson when i had my first e-cig that had oddly the same type of atty (where the cart went over the atty) so ive been really careful to not do that but thanks for the first reason it makes perfect sense
Welcome , and there are also stainless drip tips for 306's . You can also pick up a dca for 306's . They come with several different size sleeves to fit most 306 atty's as well as the main base that screws into your device . as well as a few different drip tips . The come in polished or black , and maybe others ( not sure ) I never use a plastic drip tip , now that I have a DCA. and the best part is , it never leaks .
NP... the black derelin ones tend to need to be put on further down as they warm up and then they cool like that... kind of a catch 22 (it warms up and looses a good seal so if you tighten it stretches and if not it may leak)
- Status
Similar threads
