510 Atomizer Not Vaping??

Status
Not open for further replies.

RossC

New Member
Jan 26, 2010
2
0
sacramento
So here is my problem. I have a joye 510 atomizer that for some reason does not want to vape no matter what I do. I have a fully charged battery and a full cart and when I try to vap the atomizer will vap for about 3 hits then just drop off and only make a little puff of vapor. Thinking the atomizer is dead I dropped a few drops of juice on the atomizer and it will vap that like crazy massive hits I can get but when the drops are all used up the vaping will stop dead. Just to double check to see if the cart is filled right I put on a different atomizer and it will vap that all good and fine. I have cleaned out the atomizer and that did not help at all. Any help would be great thanks.
 

Scubabatdan

Vaping Master
ECF Veteran
Verified Member
Jul 14, 2009
4,749
6,733
62
Dothan, AL
So here is my problem. I have a joye 510 atomizer that for some reason does not want to vape no matter what I do. I have a fully charged battery and a full cart and when I try to vap the atomizer will vap for about 3 hits then just drop off and only make a little puff of vapor. Thinking the atomizer is dead I dropped a few drops of juice on the atomizer and it will vap that like crazy massive hits I can get but when the drops are all used up the vaping will stop dead. Just to double check to see if the cart is filled right I put on a different atomizer and it will vap that all good and fine. I have cleaned out the atomizer and that did not help at all. Any help would be great thanks.

When you fill the cart, leave about an 1/16" of cart material sticking out of the cart. It could be the cart material is not contacting the bridge and is not wicking the juice. On the flip side it could be that you eJuice is to thick causing it not to flow, but works great when dripping which means you need to thin your juice out. Double check the bridge on the atty that works and the one that does not, do you have a low bridge and a high bridge? On the low bridge you might want to leave a little cart material sticking out to contact the bridge as I have suggested.
Hope this helps,
Dan
 
Status
Not open for further replies.

Users who are viewing this thread