901/808D atty 3 drips and done? I did something wrong right?

Status
Not open for further replies.

rturner76

Full Member
Verified Member
Apr 10, 2012
34
5
Minneapolis, MN
www.robertmn.com
No burnt smell no pop I looks brand new but when I fire it does nothing. So O shook it out and let it sit overnight tried again. nothing, dripped again gurglgurl blrw it out nothing. I got a bad one or is there a trick to this? Never used an atty before. I ususally use an eGo with a clearomizer but I thought I'd try it just cause I still had the 808 laying around. SHould I try again or are they just bad news. $5 a crack not a lot but don't want to keep buying 'em if this is common on those little things. Especially paying to get them shipped Anybody? the pic is a little fuzzy but it's about as close as I could get it with my camera phone
 

Attachments

  • IMG_20120505_225911.jpg
    IMG_20120505_225911.jpg
    18.7 KB · Views: 14

mwa102464

Resting In Peace
ECF Veteran
Oct 14, 2009
14,447
12,564
Outside of the Philadelphia Burbs, NJ & Fla
try bumping the bottom center pin out a bit if it's pushed in a little, use a needle or thin tweezers and pry out just a tad, did you try this ? if nothing pitch it and spin on a new one, make sure you prime it and put a good bit of liquid in the new one too, get those internal really wet, I put a carto condom on the threaded end and fill em up to the ceramic cup and let em sit for 10min or so, blow it out and then use it and drip in it
 
Status
Not open for further replies.

Users who are viewing this thread