- Status
Nice setup!! What r u workin with there.? Great lookin microcoil, hows it 1.2? Wraps? Wire?
is the top cap really tight or is there a trick to getting it off. the device is not mine and I didnt want to pull to much and break something lol
MrDee3, How do you wrap your micro on it. Do you wrap the coil first and then slide the mesh thru after the coil is installed, or do you wrap the micro on the mesh and then compress it while its on the mesh before / after installation?
Ive only ever done micros with cotton on a kayfun. Love me some micros i do
Ive only ever done micros with cotton on a kayfun. Love me some micros i do
Last edited:
I have both the noble 1 and the 2, the 2 fills the need for when traveling, I have plenty of full size high end mods that work great but sometimes it's just handy to have a really small good working pv, battery life is surprising good, better than expected, I got this because it was a fairly cheap test into the 14500 size, liked it so much now have Ba Gau coming, I switch between usually 4 flavours in a day so I tend to have lots of equipment around me ready to go, hard on the vape budget but a good way to justify a growing collection lol
Right now I have mine set up with a 28 ga micro coil 1.5 ohms with cotton just through the coil and barely into the wick hole, an auto drip per, works great, every couple tanks remove old cotton, dry burn and stuff with more cotton, takes about 30 seconds. Seems to be working for me
Whats the amp limit for 14500 AW IMR?
I wouldnt expect going below 1ohm on a mod like this, and I like the small size of it. Just curious what the 14500 battery is capable of handling.
I wouldnt expect going below 1ohm on a mod like this, and I like the small size of it. Just curious what the 14500 battery is capable of handling.
What's the length compared to the noble 1?
Sdogre, the safe discharge rate for imr 14500's is 4.5 amps.
Sdogre, the safe discharge rate for imr 14500's is 4.5 amps.
Last edited:
- Status
Similar threads
