A couple OKR-T10's I built.

[BI00dR3D]

The only difference in the two are the button sizes. The red one I call the Heat Seaker has a 12mm button and the black one, The Sarge, has a 19mm.
I decided to put the pot inside the box for two reasons. I like the clean look of the box without it on the outside and I like taking the back off and playing around with it. I am a very fidgety human being. The voltmeter does batt. life and volts to the 510. Both boxes are amazing and thanks to this forum and a few how to videos I have them.

 

[opensec]

very nice builds here, I guess this was not your first boxes was it?

 

[BI00dR3D]

The red one was.

 

[opensec]

very very decent job, well done sir, so do you have a next project in mind, never vaped on an OKR or KL or raptor, but curious about them, how do you like it? might try a build sometimes, I tend to stick with squonkers and that does not leave much room for dual batteries setup.

 

[BI00dR3D]

I made a unregulated mosfet box in a 1590g single 18650 because I was getting frustrated fitting everything in there. I am done building. It was very fun but for me it was very time consuming. If my OKRs break i may build another one. I love the okr chip, everybit as consistent as an dna imo. The batt life is amazing. Seeing i don't really take the 1590b out very much I only charge them about once a week.

 

[thetrucker]

Very nice job on these mods--keep building I love 2 see homemade stuff----keep on vaping---thetrucker

 

[holycrap]

good job i like it

 

[skull cracker]

Help pleeeezz, were can i find a okr dc dc 10 amp wire diagram with a vv meter installed? Also can you wire voltage ,up ,down with this type chip? Thank you for any leads for my build.

 

[david4500]

Check out Mamu's diagram posted here: OKR-T/10, T/6, T/3 schematic circuit

Voltage up/down is selected by turning a 200 ohm (typically) potentiometer.