Aight, me and "0siris" just ordered the "A20" LED Flashlight to mod, anyone have any experiences with these particular light? What type/Brand of epoxy should We use? Any Advise will be appreciated! Thanks!
A20 Mods
- Thread starter Justinking
- Start date
- th_trl_thread_readers 0
- Status
epoxy is epoxy imho as long as its the kid that is in two tubes and has to be mixed it will work perfect im sure iv used it on other things (like glueing the trash can lid on so the trash ppl had a hard time dumping it lol
ya no doubt man... lol we got a few tonight, so I'm pretty sure it'll be aight, just didn't know if it had to be like some electrical grade bs
I prefer to use JB weld (I think they make a clear version now as well) for everything that won't cause a short, such as mounting the connector.
I use envirotex lite -
Enviro-Tech 2008 8oz Clear Pour-On Finish
to seal up all the electrical parts EXCEPT any IC/regulators (chips) after testing. Essentially this will turn your electronics into a shock proof/water proof device. It will slow heat dissipation so make sure you dont coat any heatsinks or chips.
I use envirotex lite -
Enviro-Tech 2008 8oz Clear Pour-On Finish
to seal up all the electrical parts EXCEPT any IC/regulators (chips) after testing. Essentially this will turn your electronics into a shock proof/water proof device. It will slow heat dissipation so make sure you dont coat any heatsinks or chips.
Thanks "MASTER0FDAMPF" I was wonderin what people were using to seal, looked like hot glue, but couldn't tell :/
All the threads I seen about modding this flashlight seem to say "I got this to mod it, but it's too nice a flashlight so I'll keep it and mod something else". Good luck with your modding and I hope to see pics when you are done.
- Status
Similar threads
