Hey guys! I have recently gotten into dripping. Amazing vapor production and flavor from the set up that I have been using. I have been using dual super nano coils (https://www.youtube.com/watch?v=qpwdBKcNB9A) with 28ga kanthal sitting on top a small bed of cotton. I have come to the conclusion that this is the way that I like to vape. I like dual coils because a single coil just gets way to hot to produce the amount of vapor that I like. So with dual, I don't have to get them quite as hot to produce what's needed. I purchased a cheepy "Nimbus V5" clone to do this set up with. There are quotes around this because this particular atty isn't like other nimbus clones that I have seen recently. Well, this atty is very poor quality with very little room to work and tiny post holes to fit the larger wire. Also the post holes actually sit below the edge of the atty base so it's very hard to thread the coils into without bending the coils. I can never really truly seem to get the resistance of both coils perfectly equal, so one of them either burns cooler or not at all.
Why I am posting this I am in the market for the absolute best RDA that I can get for this setup. I need an atty that is preferably 22mm device to fit flush with my nemesis. Aslo would like great quality/good conductivity and in general the best I can get! What are your suggestions and why?
All help is much appreciated. Thank you!
Why I am posting this I am in the market for the absolute best RDA that I can get for this setup. I need an atty that is preferably 22mm device to fit flush with my nemesis. Aslo would like great quality/good conductivity and in general the best I can get! What are your suggestions and why?
All help is much appreciated. Thank you!