Advice for multiple flavors

Status
Not open for further replies.

Ontwo

Full Member
Feb 21, 2015
21
2
Alabama
Hey guys and gals. Need some ideas

First. I'm running an istick 50 with a kanger aerotech tank loaded with my current ADV which is Five Pawns - Lucena.

But I like to try a lot of flavors. What is a practical way to do this? I have a few kanger t3d tanks around. I don't want to get a new tank for each new flavor. But I also don't want to empty my ADV just to sample flavors.

Suggestions?


Sent from my iPhone using Tapatalk
 

Susan~S

ECF Guru
ECF Veteran
Verified Member
Mar 12, 2014
16,937
11,693
68
Mpls/St.Paul, MN
Last edited:

Robert Cromwell

Moved On
ECF Veteran
Feb 16, 2015
14,009
65,472
elsewhere
I also have a bunch of esmart clearos. However a dripping atomizer is best for sampling flavors. I then use my emsatries to keep each flavor I like in and label them. I just print out a paper with letters or abbrevs on them ex "B" for blueberry. Cut out the letter and tape it on the clearo with a bit of "scotch" tape. Holds up well and easy to remove if I choose to clean the clearo out and use a different flavor in it. Note some flavors are about impossible to clean up. Tobacco, Coconut, any strong spicy flavors, etc.
In a dripper you will have to rewick and burn off the coil to clean out the tough flavors completely.

I have been getting my esmart clearos for $1.49 each 1.8 ohm. And with proper cleaning they will last a couple of months or more. So far after about 2 months only one gave up so far. I am only doing 4 flavors so they get a lot of use.
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread