Advice on an MVP 2 Tank

Status
Not open for further replies.

herb

Vaping Master
ECF Veteran
Mar 21, 2014
4,850
6,723
Northern NJ native , Coastal NC now.
I run a kayfun lite clone and kayfun 3.1 clone on my MVP's.

bu2y4u2y.jpg


I am trying to decide between the lite and 3.1 , any preferences? Are your clones satisfactory because I would be interested where you bought them.

Thank you
 

RugerRob

Senior Member
ECF Veteran
Apr 16, 2014
75
23
Buford, GA
I run Kanger Protank II's with the Airflow base on them and Kanger AeroTanks on my MVP. Find with these tanks with 2.0-2.2 ohm coils I run them in P 6.5 - 7.0 Almost exclusively. The coils on these things do not wick very well sometimes and it's easy to get a burn taste. I find the more I turn the watts up on these tanks the MORE dry hits I'll get. So I run lower watts and tip the tank a bit if I'm chain vaping or trying to take huge hits.

If the tank starts to leak alot, gurgle, or give me a burnt metal taste I try rinsing the coil/atomizer and letting it dry out, if that doesn't do it I just chuck it. I find them lasting a 2-3 weeks but the again I rotate tanks... The atomizers are cheap enough but I just bought my first RBA and I'll be buying 3-4 of them so I can rotate flavors and will prob retire the Kanger Tanks.
 

jhicks3301

Full Member
Apr 25, 2014
59
47
Huntsville, AL
I run a kayfun lite clone and kayfun 3.1 clone on my MVP's.

bu2y4u2y.jpg

Now that is sexy!!!

I run Kanger Protank II's with the Airflow base on them and Kanger AeroTanks on my MVP. Find with these tanks with 2.0-2.2 ohm coils I run them in P 6.5 - 7.0 Almost exclusively. The coils on these things do not wick very well sometimes and it's easy to get a burn taste. I find the more I turn the watts up on these tanks the MORE dry hits I'll get. So I run lower watts and tip the tank a bit if I'm chain vaping or trying to take huge hits.

If the tank starts to leak alot, gurgle, or give me a burnt metal taste I try rinsing the coil/atomizer and letting it dry out, if that doesn't do it I just chuck it. I find them lasting a 2-3 weeks but the again I rotate tanks... The atomizers are cheap enough but I just bought my first RBA and I'll be buying 3-4 of them so I can rotate flavors and will prob retire the Kanger Tanks.

Thanks!!!

I have the Kayfun lite on my MVP2, just got it last week and I love it!!
I was using the iclear 30s before that.

I'm leaning toward the Kayfun
 
I have owned my ITASTE V2 for just over 2 days now, but I have been running my very loved Kanger Aero Tank on my E-go twist for over 2 weeks. I just started my second 2ohm coil yesterday due to fade.
One thing is for sure I have not gotten any juice to back up into my tip (AKA "Leak by"), there's hardly any gurgle, and there's been Zero leakage past any of the seals.
I have messed with the Air flow settings, but I always find myself going with the tank wide open.
Another thing worth mentioning is the coils for these tanks have been holding up very well to higher Voltage/Wattage settings 5V/11W.
There's plenty of smoke to please anyone and when you figure that you can have both the, ITASTE MVP V2 plus the Aero Tank for under $100.00 would have to say it's going to be difficult to get a better setup at that price point.

FYI I smoked Tabaco for over 10 years, I may miss it but I NEVER enjoyed it as much as vaping.
 
Status
Not open for further replies.

Users who are viewing this thread