Hey guys, need a little help... Recently got myself an Aerotank Mega n mini, mega vapes like a boss on my MVP2. But was vaping on it for 2 weeks and it stopped working.. reading n0n on my mvp2. Tried my spare coils on it and even push out the connecting pin and plug it back in with the insulator, still no response even on my smoktech winder. Any advice?
Aerotank Mega base not working.
- Thread starter Greymon
- Start date
- th_trl_thread_readers 0
- Status
Only thing I can think of is the pin on the bottom of the coil needs to be slightly pulled out. Maybe the pin on the base is pushed down/out too far.
I had the Aero base on one of my clones fail and for the life of me can't figure that one out. It seams so simple like nothing even could be wrong with it.
Sorry I can't be more help. Where did you buy it? return it maybe?
I had the Aero base on one of my clones fail and for the life of me can't figure that one out. It seams so simple like nothing even could be wrong with it.
Sorry I can't be more help. Where did you buy it? return it maybe?
A bit of dried juice in the bottom of the base where the coil makes contact, can sometimes do this. Have you cleaned your whole mega since you started having this problem?
Sounds like the center pin of the battery is not making a connection with the atomizer of the clearomizer/tank. This usually occurs from over-tightening the tank onto the battery connector.
Just make sure that if you use something conductive (metal) to pry up on the center pin that you do NOT hit the fire button while you are working on the battery. Or better yet, turn off the battery.
Center Pin Issue - Fixing a non firing eGo battery
Just make sure that if you use something conductive (metal) to pry up on the center pin that you do NOT hit the fire button while you are working on the battery. Or better yet, turn off the battery.
Center Pin Issue - Fixing a non firing eGo battery
I've had the same issue. remove the coil & pull the connector out VERY SLIGHTLY. Maybe 1/16" or less. It's on the bottom of the coil and contains the wire of the coil. Push the pin in the base out so it's just barely past flush. Take a very small screw driver & pull up the pin on your battery, just a little, & put it back together. I ran into this issue swapping tanks & batteries around. Some connectors will push the connectors in to far, especially if over tightened. Don't tjghten them very much. Just barely snug is plenty. Hope this helps.
Last edited:
Thanks for the advice, dont think the problem lies with my mvp2, cause my ego cant detect my aerotank mega base as well. Ive tried pulling both connectin pins out, but i think the insulator that acts like a spring for the aerotank mega is weakened.. the pin keeps retracting back in
- Status
Similar threads
