Aerotank V2 kanger issue

[opticruby]

Yea ive had it for about a week and a half and now its watery so maybe its the juice and the 18mg backups i have arent great either cherry flavor tastes like if you got axe spray in ur mouth by accident

It shouldnt have gone off that quick, has it been in the sun or the heat as both heat and sun will cause juices to go off very quickly.

The cherry may just need a little steeping if its a chemical/alcohol kind of perfumy (if you know what I mean,lol), taste to it. I would definatly try steeping it. I've known very bad juices taste rather good after a good steep.

 

[deadlycheech]

Yea maybe give me short tips on steeping ? if not ill just go look on youtube.

 

[opticruby]

Yea maybe give me short tips on steeping ? if not ill just go look on youtube.

How I do it is leave it in a dark place with the lid off, after a couple of days pop the lid on and shake the bottle. Then smell (sometimes you can smell the chemicaly taste), if the smell (chemical smell), has gone give it a vape or if its still there give it another couple of days with the lid off and try again. It will go very brown but this is fine as its only the air getting to the nicotine its still safe to vape.

Some juices and flavours take longer than others so theres no set time it will take but it should improve the flavour a lot.

Sometimes juices are just too fresh as the supplyers expect them to sit on the shelves for a while hence the need sometimes for steeping.

 

[RosaJ]

You may need to pull the contact on your vision ever so slightly to make sure it's making contact with the Aerotank. I have the same problem with some of my tanks if I'm using twists or vision spinners.

 

[deadlycheech]

Rosaj how whould i go about doing that? and thanks optic for the info

 

[RosaJ]

With a pair of tweezers, just pull the flat round contact on the vision spinner very slowly. I have that problem when I screw in the tanks too hard and it pushes the contact down into the housing of the vision spinner/twist.

Be careful as you may pull it out altogether and of course you don't want to do that. Give it a little pull and try the tank, do this a couple of times and hopefully it will fix it. Good luck!

 

[deadlycheech]

Thanks rosaj it was a combination of gunky coil and prying up the contact a bit in the vision spinner atleast it seems to be working better as of now

 

[NoFumus]

I had that issue with the pin myself, in this case because I was screwing it too firmly into the charger. I ended up buying a new spinner until the second time my battery stopped working and someone at my local vape shop pointed this out. If you have a light on your charger, screw in the spinner JUST until the light turns red, and no more.