Aerotank V2 Problems...

[TheVapingNewfie]

So, I have an Aerotank 2 on a mvp 2.0.
The first day I got it, I put the airflow on max and turned the mvp up to 11 W. It was alright, though there was some slight gurgling/popping.

The second day, it's burnt. Nothing I do will stop it - Turning the airflow into a pinhole, turning it to 3.3v, new coils provide the same lovely burnt taste.

I prime the coils, wait a few minutes, and dry pull before hitting it every time. Same problem.

Completely washed out the tank, and replaced the liquid, same problem.

Yes, It's authentic.

I'm not interested in buying a subtank or anything else at the moment, really. Just dropped 100$ on this set up. (Now aware that I should have bought a subtank + istick 50w)

Any suggestions or ideas would be appreciated.

 

[Das Auto]

Sounds like the cotton is burnt. Washing the tank and replacing the liquid won't change that. If you have a replacement coil to through in there (this is assuming your using a non-Rebuildable) that should cure ya! Once the cotton is burnt, it's burnt and that's that. Surprised that 11W would have burnt it, but sometimes, the cotton just isn't wet enough i guess! Happened on my Subtank Mini OCC coils the first time I used it too!

 

[TheVapingNewfie]

Replaced coils twice, same problem

I said the first day was "alright", but that seems like an understatement considering that it's now unvapable.
I either get a burnt taste, hardly any vapor, a horrible throat hit, or any variation of the three. I don't even know what to think of it, haha.

 

[Das Auto]

Huh! Twice! Well that sucks!! What VG/PG ratio juice to you vape? Could be its not burnt just "Harsh" if you PG is too high. Or nic content as well. once you get a "better" tank set up and higher wattage/voltage, you will likely need to decrease your nic content.

 

[TheVapingNewfie]

Attempted two more coils. First one I let sit for an hour, Dry pulled many, many times. Burnt.

Second try, I let sit for 15 mins, dry pulled again, didn't seem like it was working, so I thought it might have been vapor lock. I unscrewed the top cap enough so some air bubbles came up and screwed it down again. No luck, slight burn. So, unscrew the top cap so more air bubbles come up, end up flooding the coils.

I'm suppose to be vaping Halo juices. I think it's something like 60/40 vg/pg. Perhaps 50/50.

I just have no luck, haha

 

[TheVapingNewfie]

Anyone have any ideas?

 

[TheVapingNewfie]

You may be right. The contact pin on the bottom of my tank has been pushed up, nearly past the threading.. But, every time I screw it back on to my mvp, the pin pushes back in. I'm not even wrenching it on there haha

Any ideas?

 

[TheVapingNewfie]

Still have problems... at this rate, theres not even any point to try another coil. I know it'll burn as soon as I hit the power button, and I'd rather not waste any more of them...

Anyone?

 

[TheVapingNewfie]

The base isn't shorting out, coil still fires and battery reads 1.9 ohms.

Any other ideas?

 

[Jwaterski]

No idea why you're having such miserable luck with your vape. I have the aero v1, never really liked the dual coils but didn't have the burnt taste you're experiencing. I use single coils, mostly ones I have rebuilt, might give that a try. If the heads you have are the slotted type, it's easy to recoil and rewick. Since they already taste bad, nothing to lose.