With inspiration from Todd I decided to try make a decent Spheroid type atty from the bits I already had.
The parts I used where a top cap and plastic tank from an Aga-T, the base from an Igo-L, metal drip tip, center tube from an old type clearo.
First I used a nut and bolt to put the top cap in a drill and using a large sharp drill bit for a cutter I took the threading off the top cap so the tank would fit inside, then I used some Epoxy to stick the tank inside the top cap.
Next day after dry I used the same large drill bit for a cutter again to bore out the bottom section of the tank so the base would fit, I kept checking the base for size but actually went a little too far and it was slightly a slack fit so I used an O ring from the Aga-T spares which fit perfect.
Then I drilled out the end of the drip tip with a 6mm bit so the tube would slot in, popped in some filler/wadding, made a coil + wick, filled it up with juice and it's working fantastic and probably vapes as good as if not better than anything i've got. ;D
A few poor pics:
The parts I used where a top cap and plastic tank from an Aga-T, the base from an Igo-L, metal drip tip, center tube from an old type clearo.
First I used a nut and bolt to put the top cap in a drill and using a large sharp drill bit for a cutter I took the threading off the top cap so the tank would fit inside, then I used some Epoxy to stick the tank inside the top cap.
Next day after dry I used the same large drill bit for a cutter again to bore out the bottom section of the tank so the base would fit, I kept checking the base for size but actually went a little too far and it was slightly a slack fit so I used an O ring from the Aga-T spares which fit perfect.
Then I drilled out the end of the drip tip with a 6mm bit so the tube would slot in, popped in some filler/wadding, made a coil + wick, filled it up with juice and it's working fantastic and probably vapes as good as if not better than anything i've got. ;D
A few poor pics:
