I wonder if any of you kayfun users share my experience with them. I have found that they are prone to flooding and leaking simply by pulling harder than the vaporisation rate. This becomes more pronounced as batteries weaken in mech's. I intuitively draw harder as the battery weakens, which is the opposite of what should be done to avoid flooding and leaking. This has been my only issue with Kayfuns after many months of using them. Does this happen to any of you?
Edit: asking here because I know and like you guys, and I don't venture into the other threads these days
I guess I've noticed that, too. It does says to take a nice, slow, easy draw in the instruction manual.
I've just had problems with them leaking at any point in my use, but one real hard draw/pull....and it's like start over.
It's a bit too fiddly for my likes, with 50-eleven reasons folks give about why juice is leaking. Check one of the 30 o-rings, check the center post, check the air hole, check the juice channels, check the wick, check the check, LOL......
At least I know with my drippers it's either the coil or the wicking used that causes a problem.
I wonder if any of you 