All my RBA gear has arrived !

[rzil]

That's it , all the stuff are here except for some screwDrivers for coil building (but I'll just a paper clip for that) .

When i find some time this weekend , I'm going to clean my kayfun and start building .
the only thing that upsets me a little that the ohmMeter seems to be off by 0.2 + , I tried it with my PT2 ..

 

[sando7]

hope you enjoy building coils, if you have any small drill bits you can use them (wrap on the chuck end of the bit)

 

[prairie guy]

its possible that meter is good and the PT2 is + .2. coils have a tolerance and some I have even read +.3

 

[Explicit]

Which rebuild-able did you get? (Kayfun - I should pay more attention) After about 6 years of vaping I FINALLY got a one last week and have been struggling to make things work properly. My wife thinks it is funny watching me struggle to thread the coil through the posts.

 

[Clark F]

I surprised you didn't get a small blue screwdriver with KF as you can use that short term until you get a something else.

Explicit > It will get easier the more you build. My GF laughed at me so I had her give it a try, after 1/2 she gave up. I have no idea why but securing the right side first helped me quite a bit. Keep at it and you will have it on in no time and begin the wicking challenge.

 

[rzil]

Which rebuild-able did you get? (Kayfun - I should pay more attention) After about 6 years of vaping I FINALLY got a one last week and have been struggling to make things work properly. My wife thinks it is funny watching me struggle to thread the coil through the posts.

I got the kayfun 3.1 clone from FT and with that came a keychain screwdriver , not really sure it's good enough though

 

[classwife]

Moved to Rebuildable Atomizer Systems from APV Discussion