Am I doing it right? (Igo-L first RDA)

[jonathanxx]

Ok so it's my first RDA , I tried pretty much anything else in vaping, starting with 510 , ego and all that and I always came back to cigarettes after a while.
But lately I got my hands on a stingray clone and an igo l , good 70vg 30pg juice and so far I have the best experience.
Flavors, vapors and the most important for me, consistency of hardware are all there now.
No more messing around with cartomizers and all that that leaks and have poor flavors and vapors.
Now I just want to ask you guys if I seem to have my cotton set at the place it should be.
Is it better to put it all like a bed under the coil or like you see in the picture?
Right now my build is at 0.6 and it's vaping like a beast , I tried a 0.5 build but all I had was burnt taste.
I have a plume veil clone to further experiment[emoji1]

 

[Rat2chat2]

I started out dripping with the igo-L's and loved them. Probably why the only thing I will use now is a reo because they are the ultimate dripper. Still use these for my mixing and have always been pleased with their performance. Good luck to you.

 

[jonathanxx]

Just a question, how high should the coil be ? I mean should it be beside the screws , in the middle or lower than the middle .
Right now mine is almost beside the screws , so pretty much high.

Envoyé de mon Nexus 7 en utilisant Tapatalk

 

[classwife]

Moved to Rebuildable Atomizer Systems from Tips and Tricks

 

[jaxgator]

I have a plume veil clone to further experiment

Check out my Plume Veil build with rayon: http://www.e-cigarette-forum.com/fo...veil-build-w-rayon-perhaps-tutorial-some.html

Just a question, how high should the coil be ? I mean should it be beside the screws , in the middle or lower than the middle .
Right now mine is almost beside the screws , so pretty much high.

You want your coil at the same height as the air hole and as close to it as possible without touching the side wall.

 

[jonathanxx]

Check out my Plume Veil build with rayon: http://www.e-cigarette-forum.com/fo...veil-build-w-rayon-perhaps-tutorial-some.html



You want your coil at the same height as the air hole and as close to it as possible without touching the side wall.

I've seen videos of rip tripper where he tuck the cotton under the coil, is it better to tuck it under or not ?
I tried both method and it seems to work fine both way, maybe its a bit tighter on the the draw when its tucked under the coil, I don't really remember.

Envoyé de mon Nexus 7 en utilisant Tapatalk

 

[jaxgator]

I don't tuck my wicks under the coils but have seen where others do. My wicks are working well with my technique so I see no reason to change. YMMV

 

[jonathanxx]

I've seen videos of rip tripper where he tuck the cotton under the coil, is it better to tuck it under or not ?
I tried both method and it seems to work fine both way, maybe its a bit tighter on the the draw when its tucked under the coil, I don't really remember.
Also I have a stupid question, when I wet my cotton I drip some on the coil also, is it ok to do so?

Envoyé de mon Nexus 7 en utilisant Tapatalk

Envoyé de mon Nexus 7 en utilisant Tapatalk

 

[jaxgator]

Also I have a stupid question, when I wet my cotton I drip some on the coil also, is it ok to do so?

Absolutely.