• This forum has been archived

    If you'd like to post a thread, post it here instead!

    View Forum

Anyone here used fasttech.

Status
Not open for further replies.

terry w

Vaping Master
ECF Veteran
Verified Member
Sep 1, 2012
8,666
10,916
Manchester UK
Ok so today's update from yesterday, if that makes sense :confused:

Got order no 10 yesterday before I went to work, no 9 hasn't arrived yet.

So now I've got my Private V2- time to change my sig again, some more funky drip tips, a decent mod case and some coils. Quite impressed with the coils they have no res wire legs, which I was hoping they had. Bought them to use in my ithaka, so they'll work great. I've got 15 of them, so should last me a while :D

My FT wishlist is still growing and I've got loads of items to review now, so I'll get my rebate points total up in no time :thumbs:

Let us know your opinions on the private mate,

I should have mine in a few days.
 

Socalvapster

Senior Member
ECF Veteran
Jul 21, 2010
113
34
Rosemead, California
righty hoo,

All done, two new wicks 3 mm doubled into a loop, Dry burn firing like a tornado jet. Primed, sleeve on just using the smallest airhole.

Let it sit for 5 mins, 10 drops of berry mix, took a pull and was blown away. I really must put it away now till i get my low nic liquids, as i am getting nic`d out seriously. It is still a bit harsh, but that is with 18 mg. way too high.
I just got my Private V2 and using the Trident clone also set on the dual holes. I'm also blown away by the performance and getting nic'd out also dripping 24mg, had to lay down for a bit. Dual coil 2/3 wrap 30g Kanthol @ .4ohms. I'm now able to use my Panasonic CGR18650CH button tops. I also have a brass Origin mod by Footoon and feel the performance is the same.
 
Last edited:

terry w

Vaping Master
ECF Veteran
Verified Member
Sep 1, 2012
8,666
10,916
Manchester UK
I just got my Private V2 and using the Trident clone also set on the dual holes. I'm also blown away by the performance and getting nic'd out also dripping 24mg, had to lay down for a bit. Dual coil 2/3 wrap 30g Kanthol @ .4ohms. I'm now able to use my Panasonic CGR18650CH button tops. I also have a brass Origin mod by Footoon and feel the performance is the same.

hey socal,

You must have iron lungs vaping 24 mg on the trident LOL. Are you using ribbon wire or plain for your coils ? I am using .5 ribbon, 4 wrap duals gives me .5 ohm
 

trouble1000

PV Master of Valinor
ECF Veteran
Verified Member
Mar 22, 2013
5,583
8,669
Rochdale, Lancs, GB
www.puffin-eliquid.com
Let us know your opinions on the private mate,

I should have mine in a few days.

Impressed with it mate, the brass contacts really do make a difference. Almost as good as my Paps to be honest, now that is high praise :thumbs: For the price it really is a must have. I got the cheaper one of the three, but to be honest, I don't mind the aluminium tube, nice and light weight.
 

trouble1000

PV Master of Valinor
ECF Veteran
Verified Member
Mar 22, 2013
5,583
8,669
Rochdale, Lancs, GB
www.puffin-eliquid.com
Well today's update :

You know about the Private, so we'll skip that.

Got order no.9 today:
Toolkit (so I don't have to use my oily pliers anymore) - should improve the flavour of my coils :laugh:
3 x X9 Protanks, being cleaned as we speak, look as good as the original though.
6 x Panny 18650 protected batteries, for a bit of mod safety, currently charging now.

So, all I'm waiting for now is the tri-colour k100 from FT.

Big news though, I've just ordered a high end atty for the Paps Lux. I was after either the Russian 91% or the Kayfun Lite. The Russian is out of stock til next month, but managed to order a Kayfun from cloud9vaping today. Should be her tomorrow (special delivery). Proper excited now :D
 

terry w

Vaping Master
ECF Veteran
Verified Member
Sep 1, 2012
8,666
10,916
Manchester UK
Well today's update :

You know about the Private, so we'll skip that.

Got order no.9 today:
Toolkit (so I don't have to use my oily pliers anymore) - should improve the flavour of my coils :laugh:
3 x X9 Protanks, being cleaned as we speak, look as good as the original though.
6 x Panny 18650 protected batteries, for a bit of mod safety, currently charging now.

So, all I'm waiting for now is the tri-colour k100 from FT.

Big news though, I've just ordered a high end atty for the Paps Lux. I was after either the Russian 91% or the Kayfun Lite. The Russian is out of stock til next month, but managed to order a Kayfun from cloud9vaping today. Should be her tomorrow (special delivery). Proper excited now :D

I bet you are exited mate,

They do look good the kayfuns, where is your trident Ian ? is it in the uk yet. Just a word of warning, if you are using 24 mg, read socals review of it, further up LOL
 

trouble1000

PV Master of Valinor
ECF Veteran
Verified Member
Mar 22, 2013
5,583
8,669
Rochdale, Lancs, GB
www.puffin-eliquid.com
I bet you are exited mate,

They do look good the kayfuns, where is your trident Ian ? is it in the uk yet. Just a word of warning, if you are using 24 mg, read socals review of it, further up LOL

Didn't order a Trident mate. I have it in the wishlist though.

I'm glad I got the lower nic juices last week for the drippers, you were right about the nic hit, blows you away :laugh:

My Kayfun has been shipped now, so fingers crossed for delivery tomorrow :thumbs:

Right off to dry out my X9's and a few other bits.
 

terry w

Vaping Master
ECF Veteran
Verified Member
Sep 1, 2012
8,666
10,916
Manchester UK
Quick update on the trident,

Had my tea, and thought hmm lets drip some grape. I put 6 drops in and it was fantastic, the harshness has completely gone. so when i had finished my little session, i opened it up to have a look.

Only one of the coils firing, one must have popped somewhere down the line. so to sum up, i am going to run it single IMO it performs better.

No more lung and throat burn at all, really pleased with it now. After all i only have my V5 running with one coil, and i get serious clouds with both now. Yep just confirmed my suspicions, resistance has now jumped from .5 to 1 ohm.

So that settles that, I will build a single mega 9 mm wicked coil tomorrow:evil:
 

trouble1000

PV Master of Valinor
ECF Veteran
Verified Member
Mar 22, 2013
5,583
8,669
Rochdale, Lancs, GB
www.puffin-eliquid.com
Quick update on the trident,

Had my tea, and thought hmm lets drip some grape. I put 6 drops in and it was fantastic, the harshness has completely gone. so when i had finished my little session, i opened it up to have a look.

Only one of the coils firing, one must have popped somewhere down the line. so to sum up, i am going to run it single IMO it performs better.

No more lung and throat burn at all, really pleased with it now. After all i only have my V5 running with one coil, and i get serious clouds with both now. Yep just confirmed my suspicions, resistance has now jumped from .5 to 1 ohm.

So that settles that, I will build a single mega 9 mm wicked coil tomorrow:evil:

I'd like to see a photo of this 9mm wick please :laugh:

Must admit, it is surprising the difference between single and double coils, I've noticed that myself with my drippers too mate. Maybe try a cotton coil next time see what happens.
Tried dripping the yucky blackberry again today, it is getting better, about time too. Should be perfect come Christmas time :D
 

trouble1000

PV Master of Valinor
ECF Veteran
Verified Member
Mar 22, 2013
5,583
8,669
Rochdale, Lancs, GB
www.puffin-eliquid.com
Forgot to mention, been playing with the ithaka again today. Picked up a tip on another thread, about swapping the cup around in the ceramic section. Put it all back together with a single wick (one of the new ones I got from FT). Filled up with a thinner juice this time, some Red Bull with a higher PG content. Stuck it on the new Private mod, so far so good. No gurgling or leaking, quite a good vape too. Must admit it looks really good on the Private V2, looks like they were made for each other. If there's still no leaks tomorrow I'll be a happy vaper :D
 

terry w

Vaping Master
ECF Veteran
Verified Member
Sep 1, 2012
8,666
10,916
Manchester UK
vu9any4u.jpg
Sent from my GT-I9300 using Tapatalk 2

The trident single coil 6 wraps of ribbon 1.3 ohms. Perfect
 
Last edited:

trouble1000

PV Master of Valinor
ECF Veteran
Verified Member
Mar 22, 2013
5,583
8,669
Rochdale, Lancs, GB
www.puffin-eliquid.com
I`m scared :lol:

Looking good there mate, but if I don't hear from you for a while, I'll know the reason why - nicotine overload :laugh:

Seriously though, that looks like a decent looking coil you've got going there, 1.3 ohms is probably a bit low for me though.
 

terry w

Vaping Master
ECF Veteran
Verified Member
Sep 1, 2012
8,666
10,916
Manchester UK
Looking good there mate, but if I don't hear from you for a while, I'll know the reason why - nicotine overload :laugh:

Seriously though, that looks like a decent looking coil you've got going there, 1.3 ohms is probably a bit low for me though.

Well considering i have been running it at 0.5 mate, there should be a big difference.

I will report back later, once i have plucked up the courage to use it.:laugh:
 

trouble1000

PV Master of Valinor
ECF Veteran
Verified Member
Mar 22, 2013
5,583
8,669
Rochdale, Lancs, GB
www.puffin-eliquid.com
Today's update :

Ithaka is now cured. No leaks, great vapour and taste, very happy.

Got my kayfun lite today too, it's one sexy looking beast :wub:

Did a quick 6 wrap coil with cotton. But in my haste to set it up, I used the wrong wire (some old high resistance stuff, that I should have binned ages ago). Came out at 4.8 ohms on the Vamo :facepalm: Tried it anyway, no hot spots and plenty of popping and vapour when I wet the coils.

Used it on the Paps Lux, hardly any vapour at all. So I'm having to use it on the Vamo at the moment. But God what a vape at 9 watts. Loads of vapour, flavour and throat hit - I'm a happy bunny :laugh:
 

terry w

Vaping Master
ECF Veteran
Verified Member
Sep 1, 2012
8,666
10,916
Manchester UK
Have you tried it yet mate, still breathing :lol:

Yes mate,

I am on it right now. Umptious clouds of fruitiness with the watermelon. It is no where near the harshness of the sub ohm coils i was using.

I am really enjoying this right now ian, So much so, that i don`t think i will go the sub route again. But at least i tried.:p
 
Status
Not open for further replies.

Users who are viewing this thread