Anything I can do to make skin to stick again?

[yovengo]

I currently have a clear carbon fiber on my hana dna 30. Love the skin but the skin around the 510 connector is coming off/ loose. Was wondering if there is anything I can add underneath the loose skin part to make it stick again without causing damage to the box itself? Thanks for any help!

 

[Thrasher]

Try rubber cement

Good and sticky, yet later on will clean off with not much effort.

 

[Mogar]

if it is a 3M product, try using heat first. Clean the area well and put the sticker somewhere hot (I would use steam if you have access without burning your fingers) and reapply.

 

[caferacer]

It puts the lotion on its skin, or else it...ah, nevermind.

 

[yovengo]

Thrasher" data-source="post: 15837627" class="bbCodeBlock bbCodeBlock--expandable bbCodeBlock--quote js-expandWatch">

Try rubber cement

Good and sticky, yet later on will clean off with not much effort.

would it leave any bad residue, that will be seen without the skin?

 

[yovengo]

if it is a 3M product, try using heat first. Clean the area well and put the sticker somewhere hot (I would use steam if you have access without burning your fingers) and reapply.

Yeah I think it is 3M not sure but it has texture clear carbon fiber

 

[caferacer]

would it leave any bad residue, that will be seen without the skin?

Rubber cement shouldn't leave any residue, but you'll have a hard time getting the skin to lay flat after you apply it. I would start with Mogar's suggestion.

 

[Thrasher]

Yea I didn't think of how thin some of these skins are.