Anything to vape and clean atty

Status
Not open for further replies.

Switched

ECF Guru
ECF Veteran
Feb 18, 2010
10,144
2,544
Dartmouth, NS Canada
Is there anything you can add or vape that cleans the atty at the same time?
Kinda like gasoline addative that cleans the engine?
I'm using Juice up to 35% vg and I'm getting restricted air flow.
Yoy might start by decreasing your VG to 20% or below, not an additive but you'll get better MPP.
 

sjohnson

Super Member
ECF Veteran
Nov 12, 2009
524
13
Dunno about that. My base liquid is always 15 ml PG, 10 ml glycerine and 5 ml Vodka, everclear or water. That comes out to 33% glycerine and I have no issues with draw on a clean atomizer.

Is this atomizer a 510 type? If so, a plastic disc just above the battery threads on the atomizer has a solitary hole through which all air must pass. The plastic often melts, first making the hole smaller, then sometimes even closing it. Makes for a very hard draw. With care and a good light, you can see the disc and the hole from the bottom of the atomizer.

If this is the case, either toss the atomizer or use a 1/16" drill bit to re-open the hole.
 

Switched

ECF Guru
ECF Veteran
Feb 18, 2010
10,144
2,544
Dartmouth, NS Canada
I just cooked two 801s with HV Xhaler juice in a matter of days. The other 2, I use with my concoctions, all are well below 20%, 20 being the highest. The reason why I can blame the juice is that when one atty goes, we say oh well, it's a bad atty. 2 atties go, you go WTF. What is the common denominator. All these atties are/were used on a regulated 5V box mod. My juices and atties are still performing like new, along with not only my 510s but LRs as well.

FWIW folks are going through LR atties elft righ and centre, when you read the posts, the common denominator is readily apparent, yet folks refuse to see it.

I'm tired of discussing why attys perform or not. Those are the only two that cooked since I started. the other was fried because the battery switch accidentally stayed on. Is there a corolation? Heck if I know, but if things aren't working, maybe the old polar bear just might be on to something.
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread